Wireless

Dear,I am trying to associate a 1120 and 1231G AP's to cisco WiSM 1 ios version 5.i have started with converting the AP's to lightweight image using TFTP. and then connecting them directly to the cire switch and configure the port as follows:interfac...

Hello, I have problem in this wirelles router. How to enable web interface via the console? (Port COM1) Command Ip http server is bad.System say unknown command,Why? This device is new.Start device: I hold mode button and switch on power supply.LED i...

Hello,I am using a spa508g with 7.4.9c. I think I have found a bug.I use TCP for signaling.I receive a call,I send a REFER using blind transfer. The phone first send a invite to put the call in hold (as soon you hit bfer), then the refer. If I then t...

Hi,I am looking for an access-point or a router that has DHCP-client enabled on its Wireless side. Imagine all computers/devices are wired and don't support wireless. Here is a diagram:Service Provider----))))))))  Wi-Fi/802.11a/b/g/n (((((((((((((--...

Having an issue with connecting the WLC to an HPVlan 1 dataVlan 2 voiceVlan 10 WLCWhat are the settings on the HP to connect to the WLC?

Does anyone have any info on a WLCM 2 Controller Card?

Hi, i started getting this weird error message yesterday in WCS.http://dl.dropbox.com/u/10913656/xda/Clipboard02.jpgI have some generic and some per location templates.Admin status on/off, hreap enable are generic.Then i have templates for every loca...

I am trying to assign a static ip and default gateway to my LAP through the CLI, but after I reboot it, I lose the config and it reverts back to dhcp.Is there any command to save the config to the AP through the CLI?  I've tried all I can think of (i...

Hi,We currently run approx. 200 1142 AP’s managed by a couple of WLC’s (version 6). These are all in internal locations. We would now like to cover external areas and are looking for a simple external AP to deploy, ideally the AP will support 802.11 ...

HiI'm trying to connect a full-IOS Cisco 1142 access point as WGB to our WLAN infrastructure.I have these settings configured on our WLC:There is a Win2k8 R2 NPS (Network Policy Server) RADIUS server in the background for handling the authentications...

Hi,I am having AIR-WLC4402-50-K9 in which i have connected some access points in H-Reap Mode.I am running 7.0.98.218 code on this WLC. I have DHCP server configured on WLC. unfortunately client are not able to get dhcp ip address from dhcp server. I ...

I have a 1800W router it has a vpn tunnel built back to another 1800 router the 1800W router has one vlan built with dhcp enabled. I'd like to have the wireless dot11 push out the same dhcp as the vlan with wep enabled. have been tinkering but can't ...

Hi all,I have dozens of Cisco Aironet 1100 access points, each is managing its own wi-fi with DHCP.I had to disable dhcp on them because they are on a wired subnet where I am using the static IPs and don't want my wired clients to get DHCP addresses,...