Wireless

I have setup the above hardware and have the antenna mounted high in an RV campground about 100 x 50 yards. It does happen to be right along a river, which I know water does effect the signal. Anyways the signal is not very strong, especially inside ...

Just installed an 1142 a couple weeks ago and since day one, the output drops incriment constantly.  There is only one user connected to this AP, and it is a stand alone.  I saw somewhere that it might be dropping multicast packets, but the command "...

We had problem with wcs Audit status missmatch after upgrade to 7.0.164.3  WLC : 6.0.188.0.how I can fix the problem?

I have multiple sites with 5508s.  They are all currently on 6.0.199.4 and when I click on a specific client and hit the link test button, I always get a failure.   I can actively ping the clients so I know they are currently connected.  Any ideas wh...

Can we send wireless traffic from WLC to Cisco IPS  to block the malicious wireless traffic and does it support all Wireless IDS signatures in Cisco IPS.

Hi Guys,We have a wireless network using Cisco infrastructure (WLC 4402, WCS, thin clinet APs).We also have guest wireless network and we are using a third party aplication for web authentication.I am trying to setup wireless guest network using WLC ...

I am setting up a MASH network using 1240 AP and 4402 WLC. After setting up a rootAP I added a mashAP and put his MAC address in the local MAC filter table! Everything was fine: mashAP joined the network, and everything was fine. After that I want...

hi there...my college using WisM (WS-SVC-WISM-1-K9) as wireless controller , Cisco 1130 access point and Cisco Secure ACS 4.X Solution Engine 1113 Appliance as radius server. For username and password, we take it from existing Oracle database.The pro...

Hi everyone,We are adding two bridges for a point to point link connecting two buildings. Currently, we have a wireless controller running 4.2.207.0 at the site with several AP's connected and room to spare for the bridges. Should I convert my two 13...

I have 1242 Access Points that I updated to C1240-k9w7-tar 124-25d-JA tar last week.  Also updated WET200 to WET200-FW-2.0.4.0-k9.img (December 2010 version).  Suddenly the bridges don't seem to stay up/communicate with the AP -- Any Ideas -- can I r...

Hello,I need to upgrade two WISM to 7.0.116.0 to be able to support 3500 series APs.Each controller in the WiSM has about 75 APs, these are mixture of 1232 and 1142 access points. I also have 4402 working as an anchor controller.Anyone knows of any i...

Hello,I would like to know if this traffic is correct... (wan link - remote APs)minute:15 minutes:I think that something is wrong... there is a high bandwidth utilization.All APs are configured with h-reap and local switching.All traffic wan link - 1...