Wireless

HelloA client asked me to config different instances in dhcp.He gave me the following config:option 43 instance 3 ip 10.5.0.1option 43 instance 4 hex 5060option 43 instance 5 hex 5060option 43 instance 7 hex 06option 43 instance 8 hex 05option 43 ins...

Hi All,This seems to have happened after upgrading to v7: I've a test guest SSID that my test client PC cannot connect to as it seems to immediately try to associate with the corporate secure SSID. The foreign controller debug showed a line that said...

I have a WLC with code 4.2.130.0, and some of my clients are being excluded from using the wireless. I believe it's because too many failed attempts on the PSK but when I look at the excluded clients list it shows 802.1X Failure and 802.1X Associatio...

Hello!I have 2 autonomous AP 1142.And i try to make 802.11n connection between them using 2.4GHz interfaces,setting of ssid of both AP's are the same, WPA2/AES, WMM enabled by default.Using GUI i can see throughput from 1 to 54 Mbit/s, but it is less...

hey all,i ma having a problem with upgrading a 1152 to lightweight mode. i have tryed the cisco Update Tool ( used it successfully on other models of AP'S)but when i try to do this one it says the lwapp image is incorect. i am using the c1250-rcvk9w8...

Our Cisco WCS4402 suddenly stopped authenticating 802.1x clients.  Public WLAN works fine.  Software version 4-1-185.  Sytem has been rebooted several times.  Any suggestions appreciated.

Hi, I have been trying to solve this problem all afternoon. I know it is a simple NAT issue but I just can't figure it out.Just installed a ASA 5505 for a new PtP fiber connection to a customer. We are extending the customers LAN to the ASA over fibe...

HI,I need to upgrade my WCS server from version 4.1.83.0 to version 7.0.164.0.  Can somebody tell me if I can do a one step upgrade, or if I need to do multiple updates before updating to version 7.0.164.0.Also, where can I get my hands on these diff...

Is there a report that I can run in WCS to show me the speed and duplex that my AP's are operating at?

I have a AIR-AP1220A Series Access Point that I am looking to up the firmware on so that I can have it run Power Over Ethernet.  The problem is I am not sure how or even where to start?  Is there a document or a how to that can help me step by step t...

Can someone share how do you deploy a new controller to exsiting mobility group? the new controller need to have the exactly same configurations with the exsiting controllers except the IP addresses. I usually configure the IPs to the new controller ...

Will a 50 ohm load on the antenna port sufficiently drop the received signal level?For a test, I have an HWIC-3G-CDMA card and an HWIC-4B-S/T card. The BRI card is connected to a satellite data terminal for an ISDN connection. The 2811 router is conn...

Hi Board,I got another QoS and Wireless question. Hope some of you Wireless gurus can help.Has the network management traffic of the WLC a CS2 DSCP marking?For example SNMP, TACACS, RADIUS, SYSLOG, NTP .... and more. I couldn't find any information i...