Wireless

Does anyone know how to search for/sort clients by eap-type.  I am trying to determine how many clients I have on the network using LEAP before we decide what ACS version to upgrade to.   Under client reports I only see "authentication" and "protocol...

We have WCS 5.2.130.0Access points are LAP1131AGThe parameters for every radio are managed via templates.Power is assigned dynamically.Load Threshold:  Max client=12.The problem that we have is that sometimes AP's accept as twice as the maximum numbe...

Hi,I have several AP´s working with WLC 4400 series. The workstation with Cisco PCI wifi cards detect high latency when I ping several servers. It´s strange because always is the same patrol of high latency. Each 20 sec 3 peaks of high latency in all...

Hey Experti have downloaded AIRMAGNET  survey & planner  and netstublmer is there any other software which  i missing for conducting my WIreless SurveyKindly suggest meThanks /Regards

Hi,Is it possible to either power on and off lightweight PoE-connected APs from the central controller and/or explicitly tell the AP to go from high-power mode into low-power mode (with all radios turned off) and vice versa?(Ideally I'd like to do th...

Just this: is it possible to downgrade a 1140 from lwap to autonomous AP?

Can someone tell me how to make a goodbackup of the database on the Cisco WCS, version 4.2.110.0 and then move thebackup file to my laptop.  I am going to upgrade the RHLE and the WCS software.TIA

I wanted to post this as it's own question although it is posted already under "Ask the experts".We've added a secondary DHCP server to our network so that if one fails or is taken down for maintenance, we don't have a gap in service.  I need to add ...

Hello,I´m working on a wireless project that uses some LAP´s 1250, 3 controllers 5508 and a WCS software to manage everything. In one of the areas there are a lot of users, around 90, this area has 6 LAP´s. Some of those clients frequently migrate fr...

I am trying to calibrate a new install that has 1 x 4404, 1 x WCS , 1 x MSE , ~50 1142'sI have everything installed and it all works but everytime I try to calibrate the wireless using Cisco Context-Aware Service Configuration GuideRelease 6.0 Chapte...

We had an outside consultant install our WCS several years ago, recently I was asked to change the campus map from the Google satellite photo to a drawing we use on our website. The question is, can this be done without losing all the building inform...

Hello,is there a way to access a lobby database on WLC by telnet?Where can I find CLI command relative to lobby ambassador management?Thank you very muchJohnny

Hello,I would like to ask you a question related to the WCS, I have the version 5.2.130 ..I wonder if it is possible that when I look for a client that is associated to some WLC, selecting the client, I get four tabs General, Statics, Location and Hi...