Wireless

We have a 4410n wireless n access point we are using for testing. Have a time getting it to power up with POE and a 3550 switch. I have disabled cpd and spanning tree. Only way to get the AP to power up is remove power from ether port and use DC a...

Hi There,I have a setup of 9 1522 APs. RAPs=3 and MAPS=6 WLC=4404 Qty 1 (v5.2). All the MAPS have only one hop to nearest RAP. The problem is with one of the MAPs. The MAP shows good signal strength but the client traffic (even ping to controller man...

Hi,I'm looking a wireless site survey planner tool for multi floor office building to estimate the number of APs and location. Not the site survey after install APs.AigMagnet is excellent for single floor but cannot provide multi floor scenario via p...

Is there a way to find out if the AP is under utilize, over utilize or has reached its maximum load? We can see the controller's CPU and memory usage but there are no such reports for Access Points. Because of this, I was wondering if there is a way ...

Hi Folks,Running into an issue upgrading from 4.2.130 to 4.2.207, receiving the following error message and wondering if anyone has run into this same issue and if so what's the fix? Cisco TAC is telling me to reboot the C6500 chassis to resolve it....

Can someone please take a look at the two configuration and tell me if there is some thing wrong or is going to work.thanks

hello guys, i feel really silly for asking this question, but i have forgotten how to convert ip address to mac-address. can some help or provide a link for me to read?thanks guys

I've downloaded WCS-STANDARD-K9-6.0.132.0.exe (205,164 KB). Each time I try to write this to a CD it errors out and the CD is not readable. Is anyobe else have similar problem? Is there a work around?

We have 4400 controller and AP 1000 series on my network that the problem is when we connected with wireless lan network then we'll can not share file or share network and share printer with wire network. what's cause of this problem ? please you adv...

I have a Aironet 1242 LWAP that, out of the box, was requireing a manual command to boot. Looking at the boot configuration: Manual Boot: Yes, is how it is configured. The ap has joined the controller, and loaded the newest code, but is still in m...

I`m looking for the best way to have laptop users antenna`s disable when connected to ethernet and re-enable when disconnecting from ethernet. I know access connections will do this but we also have Dell and HP laptops and were looking for a way to w...

I'm planning to upgrade a 4404 WLC with 75 LWAPP's, from 5.1 to 5.2.193.I read that after the WLC upgrade the AP's are automatically upgraded in groups of 10 and that the upgrade can last as long as 30 minutes. Does this mean some AP's are not functi...