Is there away to get the packets from the client out of LWAPP? I can sniff the traffic or all I get is encrypted info. I'd like to take a look at my clients traffic to see if QoS is tagging properly for some voice issues in regards to vocera. Thanks
I'm not sure really how to ask this, but I have done some testing in a classroom on my college campus using a wired connection and then a wireless connection. When connected wirelessly, I can see other devices in the network. When connected through...
---Error Log in WLC---*Feb 25 09:06:49.014: %LWAPP-3-RD_ERR4: spam_lrad.c:2040 Invalid regulatory domain 802.11bg:-ACE 802.11a:-C for AP 00:21:d8:48:5a:94*Feb 25 09:06:49.014: %LWAPP-3-RD_ERR7: spam_lrad.c:8048 Invalid country code () for AP 00:21:...
i have a problem with the windows zero configuration thinking that the cisco driver does not support the wzc. when this happens, i can never see any access points. the wzc never even attempts to scan for access points. once windows is in this mode, ...
We just got a T1 line installed for a remote location...What would be a good wireless router to get. They are going to WEBVPN into our main building. But i need a wireless router to support T1 speeds, since we are paying for it...Any help would be ap...
I had this occur on two 4402's in 1 week. Unexpected system reload based on uptime although no crash log, controller will not associate any NEW clients, existing clients OK, controller reports erroneous client count. Then after rebooting the contro...
I'm installing a Cisco AP with a power injector. I'm trying to figure out how to find out the mac address of the switch port the AP will be connected to? I've read over several posts here that all talk about solving my problem by setting the power se...
hi everybody,i have the next proble, i hope someone can help meActually I wrok with a 1522 Mesh Network,1130 LWAPP and Bridge 1400 point to point. 1522 and 1130 are asociated with WLC.I have a WLC4402 (4.1.192.22M (Mesh)image) this wlc is conected vi...
This has probably been answered before but here goes.I have a 4402 controller at my head office and 1130ap's in a couple of offices throughout the area. The controller can see the ap's no problems and if I want clients to get the same wireless ip no...
Hi, Does anyone know of a simple explanation of what signal strengths are required for wlan, SNR values and Dbm etc etc that doesnt look like a Harvard professor wrote it.Thanks
i am facing in AP Association with the controller.i have added option 60 and option 43 on cisco IOS DHCP server.option 60 ascii "Cisco AP c1250"option 43 hex f104c0a80ab1and it is correct config coz i m getting controller ip address and info on AP.bu...
I am trying ot configure MAC filters on a 1200 AP. IOS is 12.2.15 XR2. I have about 30 mac addresses configured on an access-list 700. The ACL has been applied to both inbound and outbound traffic on the radio interface (only radio, not ethernet inte...
