Wireless

Could anyone tell me if a pair of AP1410s will work if the remote antenna is obscured by trees? If so, what kind of signal loss should I expect? If not, can you point me to an alternative? The distance between APs will be about 3KM.

Hi,which is the differece between the SSID and the BSSID ?On my WIFI Bridge with "sh controller" command the output is:...Number of Supported simultaneous BSSID on Dot11Radio0: 8...is this also the limit of the maxium number of SSID ?If I need to con...

I have a 4404 controller with a Microsoft IAS server running radius. I can connect to the WLAN when I have no encryption. When I turn on WPA2 with AES and try to connect it fails. I ran the debug dot1x events enable and here is the output. There ...

Hello, I have a few questions regarding the initial set up of the WISM in my 6509E. I'm using this as a guide:http://www.cisco.com/en/US/docs/wireless/technology/wism/technical/reference/appnote.html#wp69837This step: ! -- Create the vlan in the Supe...

Is there any template for wireless projects acceptance testing?ThanksJohn

Hi,I'm looking to combine three 54Mbps Wireless radios to increase wireless bandwidth, load balancing and redundancy. My intention was to create an etherchannel using the connected Cisco 2960 switch ports but I have read this is not a recommended sol...

Hi All,I am new to wireless and trying to determine what is the best authentication/encryption mechanism we can implement for our WLAN that does need WLC's. We have six 1242 AP's and an ACS. I want to be able to authenticate both laptops and phones a...

Hi,I want so secure my WLAN against rogue LWAPPs. I found the option "Authorize APs against AAA" under "SECURITY -> AAA -> AP Policies". So, it's only possible to authorize them against my IAS RADIUS server?How dou you protect your network agaisnt ro...

I have been presented with this problem at work.A client is going to have multiple 1242AG access points, and they want to know if it is possible to have one AP push some users over to another AP, if one of the AP's is being too overloaded.ie:say you ...

was reading this..http://www.frsirt.com/english/advisories/2007/0690http://www.cisco.com/warp/public/707/cisco-sa-20070221-supplicant.shtmlthe only software we use for clients on our data network is CSSC 4.1,5.0 and soon 5.1we dont use trust agent.am...

I cannot find in the literature where this AP supports 802.11n standard.What am I missing?

Hello,My setup:WLC 44021131 Access pointsProblem: Some AP radios are shutdownand cant be brought up. out of 17 APs3 APs are like this.Trap Logs show this:AP's Interface:0(802.11b) Operation State Down: Base Radio MAC:00:1f:9e:27:6e:20 Cause=Radio Low...

Is it possible to trunk multiple vlans over to the WGB? If so how would I do it? ThankChappy

Hello,I am trying to setup TACACS+ on both a WLC and WCS. I want to use it for backend authentication, accounting and authorization on both if possible. I used the config guides to set the ACS (v3.3), WLC (v.4.2.112.0), and WCS (v.5.0.56.2).I am no...

I am interested in training courses for wireless certifications and would like to throw my question out there. I understand there is certification for CWNA non-vendor specific certication, Cisco certifications for wireless, and AirMagnet courses whic...