Wireless

Hello,I am trying to create a WLAN with WPA2 and AES for our WVoIP through WCS. Every time I try to apply the template to the controllers I receive the following error: "WPA2 Security Not Supported in this controller version". WCS is version 5.0.89 a...

I have an AP keep generating this message AP 'Cisco_AP', interface '802.11b/g'. Interference threshold violated.How can i solve this?

I have a AIR-LAP1510AG outdoor access point that I am having a connection issue with. Someone cut the RJ45 end off that connects the AP to the power injector, so they could run the cable through a wall. Now I have to be the one to fix it.What is the ...

I would like to have internal users authenticate to Wireless LAN Controller Module using Windows IAS server. What option are there for me to present to users? Do they get a separate domain username/password box? Can it pass thru their existing dom...

Hello,One question that I haven't found an answer for yet!When the location appliance reaches the maximum number of tracking devices of 2500 what happens next???It stops collecting information for new devices?It deletes information for older devices ...

On one of our 1100 APs the wireless devices that are connected cannot ping or access each other. All devices are accessible from wired workstations, as well as from the AP itself. The affected devices can also access the other wireless devices when...

as titles suggests. I have multiple controllers with ap`s assigned to them. I also have WCS which can see these controllers and AP`s.on the controller I can set tx power levels from 1 - 7 .on the WCS I can also set 1 - 7 and the Dbm value is also sho...

can there be a different controller code on the anchor controller than the oter controllers in the group. It seems like I can not get guest users to work if the controller code on the anchor is different from the controller that the user is associat...

I have 4 AP Groups (WLC: WLANs/Advanced/AP Groups VLAN) setup to limit what SSIDs each AP serves. These all show up as mismatches in WCS. I cant find any template available to configure these in WCS nor can I "Refresh Controller Values" to fix it. ...

we need to place a access point on floor. For 1 Mbps it works for 450 feet. Now walls are constructed with Mi-one tech.I need a document from which i can get information about strength of signal or obstacals that might degrade signalsplease guide usp...

Has anyone had voice issues with this code and 7921 phones. I have had to back down to 4.2.61.0 code in order to regain decent voice quality and good roaming.

With Wireless LAN Controller Module in 2800 router is it best practice to have it give out DHCP to APs, internal users, and guest users? Or can existing Windows DHCP server be used for any/all of those?

Hi:I have a WLC 4000 series and 10 APs 1200, the WLC is running in Layer3 mode, a get that all APs registered in the WLC, i running a DHCP server on the WLC all APs are getting addresses from the WLC but i don't get any address in the clients from an...