Hi Forum,We are about to buy one WCS, my vendor has requested us to buy a server with good specs for WCS. I found this:http://www.cisco.com/univercd/cc/td/doc/product/wireless/wcs/wcscfg32/wcswst.htm#wp1061082Do we really need a very good machine for...
hii started to support an old (1998) arlan 630-900 installation (warehouse).there are 7 APs covering the warehouse, all set to the same channel (ch1, 910mhz) - is this correct?with 802.11b/g equipment i would set the APs to different channels 1,6,11 ...
Hi,we are using a aironet 1200 AP and Dell laptops for clients. The clients are authenticated through RADIUS (Microsoft IAS server) and AD. The problem is that we can not use the wireless client from XP to connect to the WLAN. When we use the Dell wi...
We have deployed Cisco Airspace AP with Wireless LAN Controllers (4400).Currently we have the WLC authenticating using radius to ACS version 4.01 servers.Unfortunately when the primary ACS get rebooted all the athentication requests go to the seconda...
I just installed a Cisco 4400 series controller running software 3.2.150.6 I upgrade an IOS AP (1200 Series) to be lightweight. Now I cannot get the controller to see the AP. I checked the DHCP 43 option and it is enabled. The AP has a static ip of w...
I'm responsible for coming up with a campus solution to support 5000 end users in a campus environment. The problem that I'm having is upper management says that this system must only have one access point. Is that possible. And what would be the b...
Hello,I am looking for recommendation on a Cisco Wireless Bridge, to bridge between two buildings about 500m to 1km appart.Can someone with this experience please recommend what wireless bridge will satisfy this need. Product number would be helpfull...
Greeting,We have just upgraded two Aironet 1300 bridges (from cisco 350) on two buildings about 100 yards apart. They are only running as bridges. One is set up as root bridge and another one is setup as non-root bridge. Root bridge is in the main bu...
Hi all,I have several Aironet 1100 series access point. These are the 11.b with WEP encryption. Can I upgrade those to WPA or higher, or am I stuck with what I have? Thanks in advance for any information.
Hey all,We have a WLAN set up with 1242 lightweight AP's connected into the network via a 4402 Controller. We are experiencing random drops where the client is disconnected from the network for no apparent reason. I checked the message logs for the...
We are planning to setup an wireless network in a conference room which is around 30,000 sf.ft. We will have around 100 users who will be accessing an internal web application on one of our server in this conference room.So this wireless network is ...
Dear Support,I have a satellite (30 users) site which has a Guest WLAN running on an 1100 terminating on a PIX 515E, the 1100 is also acting as a DHCP server for the Guest WLAN.They have asked us to install PEAP, Microsoft RADIUS and/or IAS to implem...
what happened with this message:Inconsistent device state found: Device "APxxxxxxxx": ifIndex=2, MAC=00-xx-xx-xx-xx-xx: "IEEE802dot11-MIB dot11PhyOperationTable.dot11PHYType unrecognized the next notification is: StateChange: DeviceStateValidation ...
is it secure using secure network and open network on the same AP (with vlans)?i would like to use it with trunk connection to my switch and broadcast 2 ssid's - 1 for secure network and the other for public internet.
