Hello, I am trying to find Cisco docs or guide to how to configure a splash page or "Terms of Use" page when users connected to the Guest SSID. Any suggestions? Thanks in advance. ~zK
Hello Team,I have Cisco AP 1852i Series Access points with Mobility express IOS Image, i want to convert to CAPWAP ,I already download the IOS fro Cisco Software site : ap1g4-k9w8-tar.153-3.JPL.tar Most of the link i followed still the iOS not upgra...
Hi From show run in wlc 9800, I can see there are several ALCs, but looks like these ACL are not used by the WLC. The reason why I say it is because each ACL name show up once for each ACL. These ACL are not associated with something like interface, ...
We are experiencing inconsistent login prompt of captive portal for web authentication for WLAN, this is with Apple iPhones only. Android, Windows, and macOS devices do not experience this issue. This has been seen on Apple iPhones of various model...
The access point blink red, in console is possible to see "ap:" commandap: dir flash:Directory of flash:/2 -rwx 64 <date> sensord_CSPRNG03 -rwx 85 <date> mesh_port_cfg.txt5 -rwx 570 <date> env_vars4 -rwx 368 <date> capwap-saved-config-bak6 drwx 0 <da...
9115 AP does not support terminal monitor command. 9115AP#terminal monitorCommand not supported on Console How can I check the debug information by connecting the console cable to the AP?
HI We have two controllers - 5520 - primary(.5) and secondary(.7) in HA-SKURecently we upgraded the controller from 8.5.131.7 to 8.10.151.0Had a total of 112 APs on the primary controllerto avoid disruptions to service, we first upgraded the secondar...
We have had to upgrade to IOS-XE from 5520 to 9800. We then had to downgrade back to AireOS from 9800. This is all in VM platform. We are now moving the 9120's back to the 9800. The vm 5520 has been shut down. The 9800 has already had all the AP...
I'm working on setting up a vlan and need to use SVI along with this. I'm having trouble figuring out what IP address is assigned to this.Is this an IP address of an existing device, or would this be an IP that I would assign? Thank you,
Hello everybody,I have WLC 9800, IOS 17.03.04cAll APs correcty joined to WLC (about 167), type 1852. I was migrating these APs from old WLC-5508 to this new one. I configured two locations (SSID-ALL and SSID-NO-ALL) WLC-9800#sh ap location statsLoca...
Hello,I have a Cisco Aironet 3802 with the image of Mobility Express 8.5.101, I created 3 SSIDs that are not spreading, I already enabled Broadcast SSID in the 3 networks but none is shown, nor like hidden, What could be the problem?
Some clients show IP learn state and errors below, any idea? I assume this has to do with FT and 802.1r but is this a bug? Some clients work just fine.2022/04/07 14:09:09.687947 {wncd_x_R0-0}{1}: [apmgr-bssid] [17104]: (ERR): 1006.ed3f.1d60 BSSID val...
Hello everybody, We have been trying integrate 1702i LWAP into existing WiFi network running on 2802 (AIR-AP2802I-A-K9) ME controller. 1702i joins the controller, but then failed to update SW and goes to reboot.2802 ME is running 8.10.151.0 release.1...
