Wireless

Using Network Assistant 3.0, my new 1240AG WAP cannot be joined to my community... it is reported as being 'unsupported". According to Cisco docs, the 1240AG is supported if it uses IOS, which mine does. Is there a config switch I am missing? How do ...

Hi,I am receiving High Queue Drop Rate Packets Output on the Dot11Radio interface for AP1100 on the deveice fault manager - monitoring console.What could be the problem?I have the virtual interface radio down and the AP is on Root Mode.Can i delete t...

HiI have a problem with an installtion, where i have a br1300 with 2 vlans and on both vlans are wgb1200 connectect (no trunk there!)in the native vlan the clients behind the wgb gets ip addresses but not clients behind the wgbs in the 2nd vlan. i h...

I like to configuring two BR1400s EAP authentication and Dynamic 128bit WEP(or TKIP) with ACS3.3 authentication server.I think the root bridge could be have EAP seting(RADIUS server, shared secret ket, encrytion an so on) and non root brighe could be...

I am interested in upgrading the wireless system at my home in order to gain better indoor and outdoor coverage, improve security and eliminate the eyesore AP we now have. After preliminary research, it seems either the 1130AG or the 1200 series make...

Is there an update yet that will allow me to use LEAP auth with the Airespace products?thanks!bob

Is there a white paper on how to configure this on the Airespace equipment? I've noticed documentation is horrible with this product. Any help here would be awsome. Thanks

Dear NetPro,i need some expert to advice, when i put encapsulation dot1q and trunk in the switch port. i totally can't get any ip address assign by Access Point. and when i remove the encapsulation dot1q and trunk. i am able to get ip . what does it ...

Can a 1200 AP act as a DHCP Server to only my Wireless Clients? And if so how can I configure it?I have posted this in another area as well.Thanks for any help. I am new to the wireless scene. Never liked it much because of security issues.

Hi,I have two 1100APs, with that i want to connect my two lans. i don't want any other Laptops in the region should sense the my APs.What configuration needs to be done APs.Rgs,Balaji. V

I have a strange problem with 3 Dell Latitude D600 Laptops out of 15. Their not able to find the wireless network. All drivers and settings are current and exactly the same setup as the 12 Laptops that are accessing the network. Any ideas why these 3...

hi to allI am stuck in a problem, we have a aironet 1300 series with yagi antenna we get the response but it was very hi i.e 1500 msecCan any body tell me wat can i do to decrease the response time. as the distance to main branch is 5Km.Please help m...

I am setting up an AP to be a DHCP server for Cusomters to us when they come in to our office. The problem is the AP is going to our DHCP server Windows 2003 server instead of using what I configured it to use in the AP config. Any idea as to what I...

Hi.I have two 1131AG APs with WDS enabled on both of them. Currently it seems that only way to control roaming areas is to play with the require/enable/disable settings on data rates. Is this correct?I thought that client triggers the roaming when it...