Wireless

How I can manage all Cisco Controllers from one unified interface without Prime    Apply Batch config,  change SSID search for APs 

We're having two strange issues related to integrating 8540 WLCs in an SSO to a pair of HA ISE for AAA. This configuration was "ported" from a WiSM2 to the 8540....all IP addresses that were active on the WiSM2 are active on the 8540. 1) When we disp...

HiPls suggest , after joining WLC AP goes out from network & became unreachable/ping nor available.But when i check i found Static IP is configured in AP. RegardsAbhishek..

Hi guys.I'd like to enable 300 for n mode clients (they are not not ac compatible) at autonomous access point CAP3702e.I applied followin configuration:++++++++++dot11 vlan-name a81m vlan 11dot11 ssid a81mvlan 11authentication open eap EAP_METHODSaut...

Hello, I have one air-ap1572EAC-A-k9 with its power injector AIR-PWRINJ1500-2=.  I just plugging the cable to the AP from the injector but the AP do not turn on whats is the problem? Thanks

I have a spreadsheet of Mac addresses and description that I need to add to WLC all at once using CLI. can someone help with command. i know that for a single mac, i will use macfilter add under config mode. how do I add all at once.Thank youJ

Running a Meraki wireless network with a secure SSID for staff.  The Meraki AP has an IP address on the secure subnet which is permitted on the WAN.  For DNS we have the primary set to an internal DNS server and secoWireless and Mobility, Other Wirel...

Hi everyone, Do you have occurred this issue? WLC software:7.4 FUS:1.9 When we transfer image to wlc,there is the error as below: ------------------------------------------------- This may take some time. Are you sure you want to start? (y/N) y FTP C...

Hi Guys, I have some 3800 AP in production environment connected to PoE switches with 5500 WLC (AireOS 8.5.124.64). Suddenly one of them became intermittent. My monitoring tools said that the AP went up and down for several time in an hour. When I ch...

Getting below error messages while trying to Join the AP to WLC.    

In larger enterprise wireless deployments is there a way to load balance authentication requests that are sent on a specific SSID to an ISE node?  At the moment you can manually do it per SSID, or per WLC, sending to different primary and secondary n...

Hi All   There are 5GHz interfaces disappearing from our installed AP's (mostly 2700 series). All together approx. 12 AP's in the last 3 months. PoE is not the issue. Country codes are all set correctly. We've tried on several of them to set them to ...