Anyone done integration between WLC2504 (8.5.130.0) and Steel Belted Radius (6.1.2) for 802.1x authentication with EAP-PEAP-MSCHAPv2? I have done the setup but unfortunately the client was unable to authenticate against the RADIUS server. I did d...
Forum Posts
The bulk copy and replace APs function in Prime 3.2 requires the old and new base radio MAC addresses in the csv file. Prior to 3.2 it used to require the old and new Ethernet MAC addresses, which were easier to obtain. Can anyone confirm if later ve...
We have a multi-floor office building with a high denisty wireless deployment. Each floor is close to 25,000 sq feet with 6 to 7 3602i AP's per floor. There is about 1 AP per 3500 sq foot. This is mainly for Data only, but we do some voice and wil...
Hi, i try to configure 2800 with Mobility Express (ME) configuration connected to a switch on which is not possible to have a trunk port (802.1q). So I am in access port. I am using 8.5.x release and I have only one AP in ME (so it is master ME) I ...
Hi, i have problems to get connected to the AIR-AP2802E-H-K9. It´s connected via PoE module to a cisco Switch and is then connected to a Server. The interesting Thing is that DHCP sees the IP and the MAC adress of the AP, but i am still not able to p...
Hi ,Anyone know if there is any study guide from Cisco for the new version of CCNA Wireless exam ? I have found a quick refrence guide , an electronice format but that's about it.Thx .
Dear AllWe have AIR-AP1832I-F-K9, running in wism software version 8.5.131.0We already settting DCA interval change channel to be as per 6 hours with anchor time 0, however we already notice (using Cisco PI) a event log that indicate the AP change ch...
So work just gave me a new Pixel 2 running android 8.1. I can connect to the wireless but it tells me "Connected, No Internet". My coworker is having the same issue with a Sony running Android 8. It only affects Android 8.x, Android 7 works just fine...
While the MSE reports 4967 active clients, none are displayed on PI maps. Only rogue's and interferers. Client Filter is set for Show All and MSE does display Probing clients but not the attached and authenticated. Left Click the AP and they report...
Hi, Can some please help me, why my WLC 2504 assigning multiple MAC address and IP Address to one device, with change the last 6 digits of MAC Address, these are happen when they disconnected and re login but both showing associated. and have seco...
Hey, I have a 2500 WLC that i have just configured. I want to set up WLAN authentication using 802.1x using our 2012 R2 NPS server. Does anyone have a step by step guide? Thanks
i have a question someone sometimes has this ios c890-universal9-mz.156-2.T2.bin my router is no longer supported I have problems with the ios
Resolved! Wireless coverage for AP's
Dear Experts I m very new to the Wireless technologies , I want to know the below for the pre-sales part. I want to know which AP will give more coverage than other and on basis of what ??And an idea basis on what input which AP's and controller ...
I have a 2802i-B-K9 running mobility Express up and running just fine. I am not trying to expand my coverage by adding a 1815i-B-K9 to a part of the office that has low coverage. I can connect to the 2802i via the moble app, but I can't connect via a...
Hello Gents, i'm having issue with latency on wireless which is causing issues/complains about Voice apps (SfB, Slack). Also performance on Mac devices is not perfect based on the feedback from end users. Client connectivity seems to be fine in ...
