Hi,
I have two AP's configured on one site, they HREAP configured APs, connected to the same WLC, and configured on the same site name.
but i have found this on the WLC:
AP02:
H-REAP Vlan mode :............................... Enabled
Native ID :..................................... 1
WLAN 2 :........................................ 100
WLAN 3 :........................................ 100
AP01:
H-REAP Vlan mode :............................... Enabled
Native ID :..................................... 100
WLAN 2 :........................................ 100
WLAN 3 :........................................ 100
as you could see AP01 native vlan id is 100 and AP02 native vlan id is 1,
AP01 is working perfectly, but AP02 is not, it is not allowing the clients to get DHCP IP assignment, so i know that this is because the native vlan id is 1 and not 100, how could i change this?, do i must do this from the WLC? or directly on the AP02?
Please help me with this,
Regards,
Juan Pablo Hidalgo
