Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

A9K-RSP-4G v3 - Configuration register on node 0/RSP0/CPU0 is 0x2142

Hi guys,

 

we have noticed  that all the new RMAs on the network for A9K-RSP-4G are comming with the config register set to 0x2142,

HD with 80Gb and 1.8 of disk0, same as after reparticion on a 1.5 disk,

all the  cards are VID: V03.

Are these  the expected values for all V3 cards?

Thanks in advance.

 

Regards.

 

NM

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Email me the serial numbers

Email me the serial numbers and I'll check with manufacturing.

 

Thanks,

Sam

4 REPLIES
Cisco Employee

No, they should not be coming

No, they should not be coming set with the password recovery config-register.

How many have you seen this on so far?

 

Thanks,

Sam

 

New Member

Hi Sam,right, thats my

Hi Sam,

right, thats my concern...so far we have detected about six, all V3 cards, and all have  config-reg set to pass recovery, no changes were performed manually.

Some of them were already reloaded in the scope of an ongoing network upgrade, and no issues were triggered because of that, nevertheless it seems really strange.

Tomorrow i will check all the latest replaced cards on the network and let u know.

Thanks again for the quick response!

Regards

NM

Cisco Employee

Email me the serial numbers

Email me the serial numbers and I'll check with manufacturing.

 

Thanks,

Sam

New Member

Hi Sam,sent the SNs. Thanks

Hi Sam,

sent the SNs.

 

Thanks for your efforts!

 

Regards

 

NM

89
Views
0
Helpful
4
Replies
CreatePlease login to create content