I have a question for Y.1731 one-way delay, one-way-delay variance measurement in ASR9K.
From the configuration guide document, it says that in order to monitor the one-way metrics, there must be valid DTI input into RSP card on ASR9K router at both ends (details below). I am wondering if there is any other alternative like deriving time from PTPv2? It is less likely to have DTI connection for all the routers.
To configure one-way delay measurements, be sure that the following clocking prerequisites are met:
•Frequency synchronization is configured globally in its default line timing mode (The clock-interface timing mode command is not configured.)
•The clock interface (Sync 0 / Sync 1) on the RSP is configured as a DTI port using the port-parameters dti command.
•Valid DTI input signals are available for the RSP clock-interface ports.
•Both Local and remote routers are using DTI timing input signals.
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...