06-18-2014 06:37 AM
Hello,
I was curious after seeing Cisco Live slides and I configured:
lpts pifib hardware police no flow ospf unicast known rate 0 no flow ospf unicast default rate 0
on my ASR9010. I have only point to point interfaces with my neighbors in OSPF. However, after 45 minutes I have lost routes from NX7k and only from these. Other platforms were fine. Neighborship was fine though, I saw FULL state with everyone, just no routes. Does anyone know why, please?
Solved! Go to Solution.
07-01-2014 01:47 PM
Hi Pavel,
This is due to Nexus sending ospf updates on unicast address instead of multicast.
There is a enhancement bug opened on Nexus for the same.
Best Regards,
Bheem
07-01-2014 01:47 PM
Hi Pavel,
This is due to Nexus sending ospf updates on unicast address instead of multicast.
There is a enhancement bug opened on Nexus for the same.
Best Regards,
Bheem
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: