cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
515
Views
0
Helpful
1
Replies

ASR9k N7K LPTS and OSPF

Pavel Vrastiak
Level 1
Level 1

Hello,

I was curious after seeing Cisco Live slides and I configured:

lpts pifib hardware police
 no flow ospf unicast known rate 0
 no flow ospf unicast default rate 0

on my ASR9010. I have only point to point interfaces with my neighbors in OSPF. However, after 45 minutes I have lost routes from NX7k and only from these. Other platforms were fine. Neighborship was fine though, I saw FULL state with everyone, just no routes. Does anyone know why, please?

1 Accepted Solution

Accepted Solutions

bhnegi
Cisco Employee
Cisco Employee

Hi Pavel,

This is due to Nexus sending ospf updates on unicast address instead of multicast.

There is a enhancement bug opened on Nexus for the same.

 

Best Regards,

Bheem

View solution in original post

1 Reply 1

bhnegi
Cisco Employee
Cisco Employee

Hi Pavel,

This is due to Nexus sending ospf updates on unicast address instead of multicast.

There is a enhancement bug opened on Nexus for the same.

 

Best Regards,

Bheem

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: