XR OS and Platforms

cancel
Showing results for 
Search instead for 
Did you mean: 
cancel

Forum Posts

Hello all, I have a question, have someone tested the BGP flowspec client on ASR9901 ? It's IOS XR 7.1.3.I am correctly receiving FS prefix from remote FS controller but it is not programmed to hardwareRP/0/RSP0/CPU0:asr9901#show bgp ipv4 flowspecNet...

Hello,In 32-bit Classic IOS XR, one could easily view the status of craft interface LEDs (e.g. alarm lights on RPs and front panel, etc) by running the "admin show environment leds" command. However, this command is no longer supported for ASR 9K pla...

James Jun by Level 1
  • 5564 Views
  • 4 replies
  • 0 Helpful votes

Hi all, I am having a problem to access the admin exec mode of an asr 9000 which runs 6.5.When I give the admin in exec mode it transfers me to RP/0/RSP1/CPU0:x1#adminadmin connected from 127.0.0.1 using console on x1sysadmin-vm:0_RSP0# exit Thanks i...

mac87 by Level 1
  • 1727 Views
  • 7 replies
  • 0 Helpful votes

Hello,I am implementing flowspec on an NCS 5500, I accept the rules through eBGP. I am having problems because although I receive the routes correctly and I see that the TCAM has entries. The problem is that I am observing that the entries are not ha...

I have an issue with one of our ncs 540 ios-xr devices.  Somehow the HDD is coming up as locked which was not intended.  I have tried booting the USB recovery, but everything stops at HDD is locked, then a scrambled blue screen shows up. Does anyone ...

Hello, I just migrated from an ASR9001 with 6.3.3 to a NCS-57C3 with 7.7.2,  Config is almost the same and everything is working as it should.I have 4 BVI interfaces, which i know for a fact are moving data, are reporting on 3 of my SNMP servers that...