cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
962
Views
0
Helpful
0
Replies

BFD issue between ASR9K-BE and ASR903-PO

maritpra
Level 1
Level 1

Hi,

I have the topology where ASR9K bundle interface is connected with ASR900 port-channel interface and use BFD signal but the port never come up, below is the detail.

 

ASR9K            => IOS-XR 4.3.2, linecard: A9K-MOD80-TR, A9K-MPA-4x10GE

ASR903          => IOS-XE  3.10, linecard:  A900-IMA1X

 

ASR9K Configuration

=========================================================

interface TenGigE0/0/1/2

bundle id 11 mode active

carrier-delay up 0 down 0

load-interval 30

!

interface Bundle-Ether11

bfd address-family ipv4 multiplier 3

bfd address-family ipv4 destination 172.16.11.2

bfd address-family ipv4 fast-detect

bfd address-family ipv4 minimum-interval 15

mtu 9211

ipv4 address 172.16.11.1 255.255.255.252

load-interval 30

!

router isis NKT0020

interface Bundle-Ether11

  circuit-type level-2-only

  bfd minimum-interval 15

  bfd multiplier 3

  bfd fast-detect ipv4

  point-to-point

  hello-password hmac-md5 encrypted 0525261B601C401E480112

  link-down fast-detect

  address-family ipv4 unicast

   metric 10

   mpls ldp sync

  !

!

=========================================================

 

ASR903 Configuration

=========================================================

interface TenGigabitEthernet0/0/0

mtu 9194

no ip address

carrier-delay up 5

carrier-delay down msec 0

cha!nnel-group 11 mode active

end

!

interface Port-channel11

mtu 9194

ip address 172.16.11.2 255.255.255.252

ip router isis NKT0020

load-interval 30

carrier-delay up msec 50

carrier-delay down msec 0

mpls ip

mpls ldp igp sync delay 10

mpls traffic-eng tunnels

mpls traffic-eng backup-path Tunnel62011

bfd interval 15 min_rx 15 multiplier 3

no bfd echo

isis circuit-type level-2-only

isis network point-to-point

 isis metric 10

isis authentication mode md5

isis authentication key-chain ISIS

ip rsvp bandwidth

ip rsvp signalling hello bfd

end

!

router isis NKT0020

bfd all-interfaces

!

=========================================================

 

ASR9K BFD status

=========================================================

RP/0/RSP0/CPU0:pn1#show bfd session detail destination 172.16.11.2

Fri Mar 28 12:12:03.656 BKK

I/f: TenGigE0/0/1/2, Location: 0/0/CPU0

Dest: 172.16.11.2

Src: 172.16.11.1

State: DOWN for 0d:0h:8m:48s, number of times UP: 0

Session type: PR/V4/SH/BM

Received parameters:

Version: 0, desired tx interval: 0 us, required rx interval: 0 us

Required echo rx interval: 0 us, multiplier: 0, diag: None

My discr: 0, your discr: 0, H/D/F/P/C/A: 0/0/0/0/0/0

Transmitted parameters:

Version: 1, desired tx interval: 12 s, required rx interval: 12 s

Required echo rx interval: 0 us, multiplier: 3, diag: None

My discr: 2147549186, your discr: 0, state DOWN, D/F/P/C/A: 0/0/0/1/0

Timer Values:

Local negotiated async tx interval: 2 s

Remote negotiated async tx interval: 12 s

Desired echo tx interval: 0 s, local negotiated echo tx interval: 0 s

Echo detection time: 0 s, async detection time: 0 s

Local Stats:

Intervals between async packets:

   Tx: Number of intervals=100, min=1670 ms, max=2001 ms, avg=1841 ms

       Last packet transmitted 458 ms ago

   Rx: Number of intervals=0, min=0 s, max=0 s, avg=0 s

       Last packet received 0 s ago

Intervals between echo packets:

   Tx: Number of intervals=0, min=0 s, max=0 s, avg=0 s

       Last packet transmitted 0 s ago

   Rx: Number of intervals=0, min=0 s, max=0 s, avg=0 s

       Last packet received 0 s ago

Latency of echo packets (time between tx and rx):

   Number of packets: 0, min=0 us, max=0 us, avg=0 us

Session owner information:

                            Desired               Adjusted

  Client               Interval   Multiplier Interval   Multiplier

  -------------------- --------------------- ---------------------

  bundlemgr_distrib    15 ms      3          12 s       3        

Session association information:

  Interface            Dest Addr / Type                   

  -------------------- -----------------------------------

  BE11                 172.16.11.2                            

                       BFD_SESSION_SUBTYPE_RTR_BUNDLE_INTERFACE

 

I/f: Bundle-Ether11, Location: 0/RSP0/CPU0

Dest: 172.16.11.2

Src: 172.16.11.1

State: DOWN for 0d:1h:6m:20s, number of times UP: 0

Session type: PR/V4/SH/BI

Session owner information:

                            Desired               Adjusted

  Client               Interval   Multiplier Interval   Multiplier

  -------------------- --------------------- ---------------------

  bundlemgr_distrib    15 ms      3          15 ms      3        

Session association information:

  Interface            Dest Addr / Type                  

  -------------------- -----------------------------------

  Te0/0/1/2            172.16.11.2                            

                       BFD_SESSION_SUBTYPE_RTR_BUNDLE_MEMBER

=========================================================

 

ASR900 BFD status

=========================================================

DN1#show bfd neighbors ipv4 172.16.11.1 details

 

IPv4 Sessions

NeighAddr                              LD/RD         RH/RS     State     Int

172.16.11.1                             1/0          Down      Down      Po11

Session Host: Hardware

OurAddr: 172.16.11.2   

Handle: 1

Local Diag: 1, Demand mode: 0, Poll bit: 0

MinTxInt: 1000000, MinRxInt: 1000000, Multiplier: 3

Received MinRxInt: 12000000, Received Multiplier: 3

Holddown (hits): 0(0), Hello (hits): 12000(0)

Rx Count: 0

Tx Count: 93

Elapsed time watermarks: 0 0 (last: 0)

Registered protocols: TE/FRR CEF

Downtime: 00:00:01

Last packet: Version: 1                  - Diagnostic: 0

             State bit: Down             - Demand bit: 0

             Poll bit: 0                 - Final bit: 0

             C bit: 1                                  

             Multiplier: 3               - Length: 24

             My Discr.: 2147549186       - Your Discr.: 0

             Min tx interval: 12000000   - Min rx interval: 12000000

             Min Echo interval: 0      

DN1#

=========================================================

 

Please help figure it out how to make this works.

Regard,

Marit

0 Replies 0