Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

Can I run static NAT44 in default VRF without ISM or VSM module?

I have to configure static NAT (1IP to 1 IP NAT44) in default vrf. I don't want to buy  ISM/VSM and licence CGv6

The traffic will be very low (maximum 10000 session per second). I don't want to place a new router. ARS9k has 4.2.1 frimware version.

Can I run static NAT44  in default VRF without ISM or VSM module?

 

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Hi Tomasz,unfortunately no,

Hi Tomasz,

unfortunately no, even at very low speed, we can not perform NAT tasks on ASR9000 without a service card.

Kind regards,

N.

1 REPLY
Cisco Employee

Hi Tomasz,unfortunately no,

Hi Tomasz,

unfortunately no, even at very low speed, we can not perform NAT tasks on ASR9000 without a service card.

Kind regards,

N.

76
Views
0
Helpful
1
Replies
CreatePlease to create content