Hello all, install a interface card in slot 1 on 0/3/CPU0, however with below error message, try reload the subslot 0/3/1, still can't power up. Do I need reboot the 0/3/CPU0 Mod 80 in order to bring up this module, or I missed something ?
MPA in bay 1 cannot be brought up as NP TM mode is incompatible with the card type.
Please perform aline card reload in order to bring this MPA module up[#0x1c9774a#]
NAME: "module 0/3/CPU0", DESCR: "80G Modular Linecard, Packet Transport Optimized"
Yes this was an issue which got corrected between 4.2.0 and 4.2.1 so a reload as I mentioned will need to be done. If you want to upgrade so that this and other issues are fixed I would recommend 4.3.4 when it comes out in about a week, the other good option is 4.2.3 (with SMU pack 3).
With XR 4.2.0 the ASR9000 is releasing a new line of hardware models. This amongst others is the RSP440, the next generation RSP with faster switch fabric along with Typhoon based Linecards, the next generation network processor.
The Cisco EPN system incorporates a network architecture designed to consolidate multiples services on a single Multiprotocol Label Switching (MPLS) transport network. This network is designed primarily based on...
Internet security is important with the increasing attacks that are happening every day. Many internet and browsing security solutions exist, but some are not very easy to use or maybe the question is how can I enable them?