Does somebody know what is the purpose of initial and active session timeout for TCP and UDP sessions in CGNAT configuration. What are their default values. Documentation specifies how to configure it but not what exactly they do.
How to specify session idle timeout or maximum connection time like on other platforms.
For TCP, suppose, once the bi-directional traffic flow is established, there is no traffic for 1800 sec (i.e., packet counter in NAT DB will not be updated). In that case, the NAT DB entry will be removed.
If RST/FIN packet is received, NAT DB entry goes into INACTIVE state and it is removed after "Initial" timer expiry (i.e., 120 sec).
You can send traffic via a TGEN (Traffic Generator) and can thus verify the behaviour.
With XR 4.2.0 the ASR9000 is releasing a new line of hardware models. This amongst others is the RSP440, the next generation RSP with faster switch fabric along with Typhoon based Linecards, the next generation network processor.
The Cisco EPN system incorporates a network architecture designed to consolidate multiples services on a single Multiprotocol Label Switching (MPLS) transport network. This network is designed primarily based on...
Internet security is important with the increasing attacks that are happening every day. Many internet and browsing security solutions exist, but some are not very easy to use or maybe the question is how can I enable them?