Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CISCO ASR901 BRIDGE BETWEEN 2 INTERFACES

Hi All!

  I'm looking for some way to make a transparent bridge between two interfaces of a Cisco router ASR901 , is there any possibility? I ask this because I have a scenario where I would use the ASR901 to the following question :

POP01 (                       ) ASR901  g0 / 6 -------- > ISG_7206

POP02 ( MPLS CLOUD )               g0 / 7 -------- > ISG_7206

POP03 (                       )

The ASR901 will focus EoMPLS with other points in the network and pass on to ISG routers , ie , VLANs would have to be two ports with XConnect to a remote router , the configuration would be something like this :

interface GigabitEthernet0/6

Core description : MPLS CONC PPPOE02

no ip address

negotiation auto

hold- queue 1024 in

hold- queue 1024 in October

!

service instance 4095 ethernet

  encapsulation dot1q 4094

  rewrite ingress tag pop 1 symmetric

interface GigabitEthernet0/7

Core description : 7206_PPPOE_01

no ip address

negotiation auto

!

service instance 4095 ethernet

  encapsulation dot1q 4094

  rewrite ingress tag pop 1 symmetric

!

end

L2VPN XConnect context TEST

ethernet interworking

member 201.55.127.202 1212 encapsulation mpls group TEST

member GigabitEthernet0 / 7 service -instance TEST 4095 group priority 1

member GigabitEthernet0 / 6 service -instance 4095

redundancy group delay 1 3 TEST

But without an interface that was redundant of other , what I need is the 2 interfaces in " bridge " making a XConnect to a remote router , and these 2 interfaces connected ISGs in 2 to make a balance .

  • XR OS and Platforms
Everyone's tags (6)
2 REPLIES
Cisco Employee

CISCO ASR901 BRIDGE BETWEEN 2 INTERFACES

Hi,

This discussion is for IOS-XR related questions. You should post your question under Service Provider > MPLS.

thanks,

rivalino

New Member

CISCO ASR901 BRIDGE BETWEEN 2 INTERFACES

Thanks Rivalino! I post the discussion on the right place.

184
Views
0
Helpful
2
Replies