Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CRS-X/16 - Dolly

Hello All,

I will have to install a CRS-X/16 in the near future and I need to understand if the "Dolly" (CRS-16-LIFT/B) from a CRS-3/16 is suitable for the CRS-X/16.

Thanks.

Regards,

Pedro

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Hi Pedro, We only have two

Hi Pedro,

 

We only have two lifts, one for the legacy chassis, and then the one you mention which is specific to the type B chassis and was introduced for CRS-3. So short answer is yes that one will work since CRS-X still uses the type-B chassis for 400Gbps, the legacy chassis with CRS-X would give you 200Gbps.

 

Thanks,

Sam

3 REPLIES
Cisco Employee

Hi Pedro, We only have two

Hi Pedro,

 

We only have two lifts, one for the legacy chassis, and then the one you mention which is specific to the type B chassis and was introduced for CRS-3. So short answer is yes that one will work since CRS-X still uses the type-B chassis for 400Gbps, the legacy chassis with CRS-X would give you 200Gbps.

 

Thanks,

Sam

New Member

Hi Sam,Thanks for your prompt

Hi Sam,

Thanks for your prompt reply. 

Another question, how can I know if the chassis is type-B or not? I have some CRSs in remote locations, and would like to know if they are upgradable to CRS-X or not.

Thanks.

Regards,

PM

Cisco Employee

If you issue 'admin show

If you issue 'admin show inventory chassis' the PID for the LCC would be CRS-16-LCC-B, both can be upgraded to CRS-X just with reduced BW on the legacy chassis.

 

If you have more questions on CRS-X feel free to email me as there are some other requirements for the migration.

 

Thanks,

Sam

69
Views
5
Helpful
3
Replies
CreatePlease to create content