Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

High bridge domain (BD) utlization

Hello,

is there any way to know which brdige domain/P2P Xconnect is getting more utlizaiton or traffic.

since many BD are sharing the same physical interface there is a need to know which BD is getting more of link bandwidh.

Mohamed.

  • XR OS and Platforms
2 REPLIES
Cisco Employee

High bridge domain (BD) utlization

Hi Mohammed,

You can run mpls netflow on the core facing interface and based on the VC label you can figure out which pseudowire is getting lot of traffic.

other way to check would be "sh l2vpn bridge-domain bd-name xxx detail" and look at the

Statistics:

        packets: received 0, sent 0

        bytes: received 0, sent 0

which will be cumbersome if you have lot of p2p in the network.

HTH,

Chander

New Member

High bridge domain (BD) utlization

Hi Hemachander,

Thanks for your respond,  what we are looking for is "input rate" or "output rate" which is

also not available on XR, even sub-interfaces showing the rx and tx as "Unknow".

with ISP 10G links facing core, it's seem to be impossible to look into these value and found out the issue from XR side.

Again, thanks for your help.

Mohamed.

186
Views
0
Helpful
2
Replies
This widget could not be displayed.