Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Silver

How do I show ACL hits for ACL's used in policy maps?

Is there a way to display the hit count against ACL entries when the ACL is used for policy maps, QoS classification etc?

The manual shows how to do this for an ACL when its attached to an interface. Also there are options for a location, it doesn't match for any of the presented locations, but does give the option for a `word' to be entered.                  

2 REPLIES

Re: How do I show ACL hits for ACL's used in policy maps?

Hello aacole,

you can try this command:

show access-lists ipv4 hardware {ingress | egress} interface location

Thanks,

Michel.

Silver

Re: How do I show ACL hits for ACL's used in policy maps?

Hi Michel,

I have spent some time trying to figure out the syntax for this command, I see how to do it if the ACL is applied to an interface, but not if its used for a policy map or qos policy. Its not clear from the command guide.

What do I use for location assuming this is the way to do it for this type of ACL? I have a read through the configuration guide, its not clear if I can look at these counters or not.

Andy

308
Views
0
Helpful
2
Replies