Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

How to configure tunable DWDM-XFP-C on ASR9010

Hi,

Currently we have a CRS-3 router connected to a 7609 router through DWDM network. In 7609 we have the following transceivers:

DWDM-XENPAK-42.14, DWDM-XENPAK-42.94 and DWDM-XENPAK-40.56.

Now, the 7609 will change by ASR9010 and the connections to DWDM will be with transceivers DWDM-XFP-C so I would like to know how can I configure this tunable transceivers.Transceivers will be installed in A9K-8T-L Linecard.

Another question, the transceivers will be installed in continuous ports in the LineCard (Te0/1/0/2, Te0/1/0/3 and Te0/1/0/3). Is there any issue or recomendation with this?.

Thanks,

Jaime Soto.

2 REPLIES
Cisco Employee

How to configure tunable DWDM-XFP-C on ASR9010

Hello Jaime,

There is a wavelength command under a DWDM controller to configure its frequency:

http://www.cisco.com/en/US/docs/routers/crs/software/crs_r4.1/interfaces/command/reference/interfaces_cr41crs_chapter3.html#wp555295626

here you can find a configuration guide

http://www.cisco.com/en/US/partner/docs/routers/asr9000/software/asr9k_r4.2/interfaces/configuration/guide/hc42dwdm.html

I am not aware of any limitations of installing XFPs one next to another.

Regards,

/A

Community Member

Hello:

Hello:

I will start using DWDM-XFP-C in a A9K-8T-L line card release 4.3.4(ASR9K). Can you please let me know i need to install any specific PIE software module or SMU in order to support the DWDM-XFP-C.

/Renato

3326
Views
10
Helpful
2
Replies
CreatePlease to create content