I am playing with mLDP for NGMVPN implementation and I noticed that when I enable LDP over the MPLS TE tunnel, the mLDP neighborship is up via that tunnel, but no binding and no route in the MPLS forwaring p2mp table is created
The question is, can we put the mLDP multicast traffic in P2P TE tunnel at all ?
1. Introduction Internet security is important with the increasing
attacks that are happening every day. Many internet and browsing
security solutions exist, but some are not very easy to use or maybe the
question is how can I enable them? In this referen...
Cisco Software Manager Server API Guide This document describes the
programmatic interfaces, RESTful APIs, which are supported by Cisco
Software Manager Server (CSM Server). Overview CSM Server supports a set
of finite RESTful APIs. The first step to use ...
If you are using Cisco's new linux-based Cisco Software Manager server,
then you probably want to make sure there is a startup service for
it.I'll assume that you've already installed the CSM server on a
systemd-based linux system. The commands given belo...