Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Netflow on ASR9K - Exporter map is disabled

Hi,

I am trying to get Netflow working on an ASR9K but the Exporter Map is constantly "Disabled", I understand that the exporter map will remain disabled if a source interface is not specified or if the source cannot contact the Netflow collector. I am missing something. I can see that the ASR is collecting stats from the cache.

RP/0/RSP0/CPU0:ASR9K-01# sh flow exporter NF-Exporter location 0/0/CPU0

Mon Jun 11 21:28:40.407 IST

Flow Exporter: NF-Exporter

Flow Exporter memory usage: 3280868

Used by flow monitors: NF-IPv4-Monitor

Status: Disabled

Transport   UDP

Destination 192.168.xxx.xxxx (2055)      VRF OAM            

Source      192.168.123.123 (1618)

flow monitor-map NF-IPv4-Monitor

record ipv4

exporter NF-Exporter

sampler-map NF-Sampler

random 1 out-of 1000

I can confirm that I can ping the Collector from the exporter map source interface ip address. The Netflow collector is gathering netflow from

other sources and is listening on UDP 2055 for v9.

I am running A9K-AIP-LIC-B license on linecard with netflow running.

Ver 4.1.1 IOS-XR

Any help is appreciated.

Rob

4 REPLIES
Cisco Employee

Netflow on ASR9K - Exporter map is disabled

Hello Rob,

Here are few things to verify:

1. Destination 192.168.xxx.xxxx should be reachable via a Line Card interface (not management).

2.  There is an issue with exporter if a route to 192.168.xxx.xxxx would be recursive:  “CSCtr62137   netflow exporter is disabled with BGP recursive route to exporter”. Fixed since 4.1.2.

Regards,

Alex.

New Member

Netflow on ASR9K - Exporter map is disabled

Hey Alex,

Thanks for that, I have looked into the bug id CSCtr62137 but can only see the SMU explicitly available for CRS's and not ASR's, maybe it is rolled up into a Tarball, I will check.

Thanks Again

Rob

Cisco Employee

Netflow on ASR9K - Exporter map is disabled

You are correct, there is no SMU for ASR9k. You can open a TAC service request for a SMU request. But normally that is a lengthy process and there is no guarantee we get it. It may be faster and simpler to upgrade the ASR9k.

Regards,

/A

New Member

Netflow on ASR9K - Exporter map is disabled

Thanks again, I have logged a case.

590
Views
10
Helpful
4
Replies
CreatePlease login to create content