07-22-2013 07:47 PM
Hi,
I would like to know what the equivalent command to enable snmp traps module and env in IOS XR.
The IOS command is like below :
snmp-server enable traps module
| |
i could not find similar command in IOS XR. is it the same with "snmp-server traps system" in IOS XR ? | |
Solved! Go to Solution.
07-22-2013 10:09 PM
Hi,
The equivalent command would be to configure "snmp-server traps fru-ctrl". Configuring this command should enable the router to send cefcPowerStatusChange and cefcModuleStatusChange traps.
Configuring SNMP on XR,
Thanks and regards,
Rahul.
07-22-2013 10:09 PM
Hi,
The equivalent command would be to configure "snmp-server traps fru-ctrl". Configuring this command should enable the router to send cefcPowerStatusChange and cefcModuleStatusChange traps.
Configuring SNMP on XR,
Thanks and regards,
Rahul.
07-23-2013 08:28 PM
Hi Rahul,
Thanks for information.
does "snmp-server traps fru-ctrl" include tempature trap ?
Thanks
07-23-2013 09:53 PM
Hey,
You will need to configure "snmp-server traps sensor" to enable the traps under the CISCO-ENTITY-SENSOR-MIB. You can use the following docs to check whether these are supported on your XR platform.
For ASR9k, (table 3-2 lists the supported Traps on the ASR9k),
http://www.cisco.com/en/US/docs/routers/asr9000/mib/guide/asr9kmib3.html#wp1602338
For the GSR XR,
ftp://ftp.cisco.com/pub/mibs/supportlists/xr12000/xr12000-supportlist.html
For the CRS-1,
ftp://ftp.cisco.com/pub/mibs/supportlists/crs1/crs1-supportlist.html
Thanks and regards,
Rahul.
01-04-2016 11:41 AM
Hi Rahul,
Besides polling CPU MIBs, is there a trap (able to send notification to a server) in IOS XR for CPU utilization? Like snmp-server enable traps cpu in IOS
Thanks and regards,
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: