There's a mobile version of our website.
I try to enter the command "ip policy route-map" on 3750's interface. But the command doesn't appear.
Why? Whereas I see several times that this command is possible on this switch.
What I have to do to enter this command?
To run PBR on the 3750 you need -
1) to be using the IP services image and not the IP Base image
2) you need to run the routing sdm template ie.
3750# sh sdm prefer
will show you the current template
3750(config)# sdm prefer routing
will enable the routing template.
Note that a change in the sdm template requires a reload of the switch.
How to activate the "Ip services image" instead of "Ip base image"?
Because I just have activated PBM like you wrote it and the command "ip policy route-map" still doesn't appear.
I use the IOS 12.2(35) version.
I have the same problem Sebastian has, and I have a cisco catalyst WS-C3750G-24PS stack with four switches.
I'm using C3750 Software (C3750-IPSERVICESK9-M), Version 12.2(55)SE8.
I also inserted the command you described about to prever SDM routing profile exactely as you described but I'm still unable to insert the command ip policy router-map statement on the virtual inteface.
What I'm doing wrong ?
Thank's a lot for yoour further suggestions
Login to share your discussion activity with your friends on Facebook. You can control what you share and turn off sharing anytime.
Your Facebook friends can now see that you have started this discussion
Your Facebook friends can now see that you have commented on this discussion
Your Facebook friends can now see that you have read this discussion