There's a mobile version of our website.
When i wrote on the system console "sh logging system" , i take
1: 10/19/10 12:55:20 5/-1: MAJ, GOLD, diag_get_fabric_status: diag_hit_sys_limit: Test skipped!
2: 10/19/10 12:55:20 5/-1: MAJ, GOLD, diag_get_fabric_status: diag_hit_sys_limit: Test skipped!
3: 10/19/10 12:55:20 5/-1: MAJ, GOLD, diag_get_fabric_status: diag_hit_sys_limit: Test skipped!
this output many times. What does it mean ?
This message is reported by GOLD - General OnLine Diagnostic feature.
GOLD perodically gets fabric status of all fabric-enabled modules. When the CPU has something (important/higher priority) to do, it skips the test.
sh processes cpu | exclude 0.00% 0.00% 0.00%
CPU utilization for five seconds: 39%/29% <<==
Total CPU usage is 39% - 10% due to processes and 29% due to interrupts.
I guess, some traffic may be getting software-cef switched.
Please review following documents and see if it helps.
Troubleshooting High CPU in Cisco Routers:
Troubleshooting High CPU due to interrupts:
As you say , i think i've problem about ip cef. On console i wrote "sh cef not-cef-switched" and took attached display.
What does "unsupported" mean ? Also this column continuously increase.
"sh cef not-cef-switched" has not been very useful. Please do "sh ip cef switching statistics feature" few times, and you should be able to identify the feature that may be sending traffic for software-cef switching.
Login to share your discussion activity with your friends on Facebook. You can control what you share and turn off sharing anytime.
Your Facebook friends can now see that you have started this discussion
Your Facebook friends can now see that you have commented on this discussion
Your Facebook friends can now see that you have read this discussion