WCS - Automatic Port Scan

[jnlawrence76]

Is there a way to set the WCS to automatically to do a port scan when a new Rogue AP is found?

[Surendra BG]

If you have WCS configured with the switches SNMP info, you can have WCS  track down exactly what port the rogue AP (and Client) are on. Is this wat you are looking for??

lemme know if this answered your question..

Regards
Surendra
====
Please dont forget to rate the posts which answered your question and mark it as answered or was helpful

[jnlawrence76]

No. I know how to do it manually.  I would like to know if there is a way to have WCS automatically do a port trace as soon as it sees a new Rogue AP.

[sschmidt · Accepted solution]

Currently the only way to initiate the switchport

trace is manually.

[Surendra BG]

ha ha you were quick was about to reply the same!! Anyways thanku..

lemme know if this answered your question..

Regards
Surendra
====
Please dont forget to rate the posts which answered your question and mark it as answered or was helpfull