There's a mobile version of our website.
I'm getting the following error when
attempting to upgrade the signature file on a SSM-20:
"Cannot parse the current config for the component signature definition instance sig0"
I am getting this exact same error when attempting to update signatures on our IDSM-2 modules.
This has happened on the last two signature definitions, S550 & S551, our IDSM-2 engine version is 7.0(2)E4.
Does anyone have a quick fix for this before I raise the issue in a TAC case?
I have the same engine version as you do. I have a TAC case open.
They had me reboot my module. Didn't fix it. I'll let you know if they come up with a solution for me.
We are getting the same issue accross the board with our AIP-SSM cards.
Looks like restoring default sig values then manually updating works. Bit of a pain as we have over 35 units to complete this on.....
Just hope it's not a regular thing .
Saving your current config and defaulting the sigs, then restoring will work. Also I was advised to try defaulting sig 23899/0 and then trying the update. I'm going to try that tonight to see if it works.
Signature update S567 has the permanent fix for the issue. Update to S567 (or later) to correct the issue. Reset 23899.0 to its default settings prior to updating.
Change signature 23899.0 to the default settings, for example:
# conf t
(config)# service signature-definition sig0
(config-sig)# default signatures 23899 0
Login to share your discussion activity with your friends on Facebook. You can control what you share and turn off sharing anytime.
Your Facebook friends can now see that you have started this discussion
Your Facebook friends can now see that you have commented on this discussion
Your Facebook friends can now see that you have read this discussion