There's a mobile version of our website.
I have just completed an 18AP install at my place of employment and we have run into a slight problem.
The Apple clients on our wireless LAN cannot discover printers through the bonjour protocol.
Am I correct in saying this would be related to either a unicast or multicast issue?
Can someone point me in the correct direction on how to begin configuring either unicast or multicast between the 5508's and other switching devices.
Currently I have the 2 5508's patched into a 3750 (which provides routing) and from that switch on, the other AP's connect from the network.
Enable Multicast Globally on the WLC..
WLC GUI >> Controller >> Multicast >> Enable Global Multicast >> Enable Snooping >> Let the timeout be in defaults (60 seconds)..
and follow the below link..
lemme know if this helps and please dont forget to rate hte usefull posts!!
i am having similar issues .. I enable snooping from 3 to 15 min... Now i am able to print or printer shows up for 15 min then it disappear again until I restart the printer again... This happen to two different printers
its a AIR-WLC2112-K9
Product version 188.8.131.52 boot loader: 184.108.40.206
Airprint may not be compatible with IGMP snooping -- I've seen cases where igmp snooping needs to be disabled for reliable service. I'm not sure if Airprint can be configured to participate in IGMP.
if i disable IGMP snooping then it doesn't even show up on the iphones or ipads.. its says printer cannot be found
if i restart the printer again its availble for 15 min or so then it disappers -
printer epson artisan 837
Login to share your discussion activity with your friends on Facebook. You can control what you share and turn off sharing anytime.
Your Facebook friends can now see that you have started this discussion
Your Facebook friends can now see that you have commented on this discussion
Your Facebook friends can now see that you have read this discussion