10-12-2011 04:24 AM - edited 03-16-2019 07:27 AM
Hi,
Is it possible to configure E1 on H.323 GW to use for example all 30 channels for incoming calls and 25 for outgoing?
regards
10-12-2011 04:43 AM
Hi,
Yes you can select some timeslots for OUTGOING.
You need to use trunk groups
Something like this
!
trunk group OUTGOING
!
!
controller E1 0/0/0
pri-group timeslots 1-31
trunk-group OUTGOING timeslots 21-31
!
dial-peer voice 9 pots
trunkgroup OUTGOING
tone ringback alert-no-PI
description *** O/G LEVEL 9 TRAFFIC TO PSTN ***
destination-pattern 9T
progress_ind setup enable 3
progress_ind alert enable 8
progress_ind progress enable 8
progress_ind connect enable 8
incoming called-number .
direct-inward-dial
!
HTH
Alex
10-12-2011 05:48 AM
For now I cannot test it. Is it possible to limit also incoming calls the same way?
Is it depended from channel selection order (which is configured on provider side)?
10-12-2011 05:51 AM
Hi,
Sorry you can not control the INCOMING.
This is controlled by your PRI service provider.
Regards
Alex
10-12-2011 05:54 AM
Thanks a lot for help.
06-01-2012 08:58 AM
Alex,
I have a similar requirement but I do not see an option to add trunk-group under controller. Did you ever test it, did it work? Any other suggestions?
Chris
06-04-2012 01:54 AM
Chris,
Yes this works for me.
PM message sent to you.
Check your inbox
Regards,
Alex.
Please rate useful posts.
06-04-2012 06:09 AM
Thanks Alex, my issue was that the trunk group was already assigned to serial interface, as soon as I removed it from serial it was available under controller.
Chris
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: