There's a mobile version of our website.
The design of my architecture is described in attachment.
As you will see, I have setup a site-to-site VPN tunnel between 2 sites using CISCO rv120w.
Everything works fine; any PC on one site can access all systems on the other site and vice-versa.
The issue I have is when I start a VPN connection another site on Internet using IPSecuritas.
I can initiate a VPN to site 1 and site 2; but when connected, I can only access servers that are located into the same site I'm connected to; I cannot ping the remote site.
The Range of IP addresses on the internet during my tests is 192.168.11.0 (I 'm using a Mac)
Systems with IP 192.168.1.1 and 192.168.10.1 are bridges
Systems with IP 192.168.1.2 and 192.168.10.2 are CISCO rv120w
Any help will be very appreciated.
I have tried to enable RIP but it doesn't help.
Have you thought about connecting to Site 1 (or 2 for that matter), using VNC or RDP to connect to a workstation or server, then using that device to connect to Site 2?
It gets interesting, but we use VPN to connect to our personal workstations via RDP, then use Real VNC Viewer from there to get to other workstations/servers (running Real VNC Server) all the time. It works great. We prefer Real VNC, but there are *free* VNC alternatives out there if cost is an issue.
Your description of the problem is not so clear and your attached is not visible to see. So I will recap from what I understood.
You are coming on remote vpn-client and connected to site “A” and site “A” has a L2L vpn tunnel to site “B”
Your problem is you cannot access resources on site “B”, when remote vpn in to site “A”, is the correct, the nature of your problem ?
Your description is exactly what I have.
To give you an idea of my configuration, I have based it on this post:
More specifically by using this document: