cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
28216
Views
5
Helpful
1
Replies

CCNA Lab Question

Haris Chaudhry
Level 1
Level 1

HI all ...

I am doing some playing around with my CCNA LAB. I have a Question About Inter-VLan ROuting...

ROuting.jpg

I want to Establish Communication Between the 2 Sites but Prevent Broadcasts and unnecessary traffic across the WAN link. etc...

The links between the ROuters and the Switches are Trunk Links...

Site A has a Scope of 10.130.19.0 /22

Site B has a Scope of 10.137.141.0 /20

So it the Solution as simple as

1. Make a Vlan (5) Called routing with an ip of lets say 192.168.1.1 /29. Make the 2 Switch access ports of that vlan .OR Trunk links with Allow Vlan (5) across trunks and deny all others...

2. Static routes on Routes on the routers 10.130.141.0 /22 192.168.1.1/29 vice-versa ?

Any Ideas which direction i should take ? I am still at very early stages of my CCNA so sorry for my stupid question...

1 Reply 1

Hello. 

I have yet to come across this type of design after so long in the field.

Switches have been created for LAN connectivity and routers for WAN.

I believe you should probably connect the routers together and the switches face tge LAN side.

All other design stays the same.

HTH.

Please rate useful posts.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: