cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2181
Views
0
Helpful
3
Replies

Basic Remote Access Setup

jeff slansky
Level 1
Level 1

Hi,

i have a pix configured inline. so cable modem --> cisco pix 525 with ios 8.0.4 --> member hosts

the pix serves as a dhcp server and router

looking to turn on remote access so that i can login from remotely to my network.

can someone outline the basic commands needed to set this up.

my understanding is there a couple of different modes, split tunnel and pure tunnel

any one would suffice to start.

jeff                   

3 Replies 3

jeff slansky
Level 1
Level 1

this is what i did to enable remote access. i can successfully authenticate but no traffic passes. i can't ping any internal or external ip or get on the internet when connected.

hostname(config)#isakmp policy 1 authentication pre-share

hostname(config)#isakmp policy 1 encryption 3des

hostname(config)#isakmp policy 1 hash sha

hostname(config)#isakmp policy 1 group 2

hostname(config)#isakmp policy 1 lifetime 43200

hostname(config)#isakmp enable outside

hostname(config)#ip local pool testpool 10.1.1.20-10.1.1.254

hostname(config)#username testuser password 12345678

hostname(config)#crypto ipsec transform set FirstSet esp-3des esp-md5-hmac

hostname(config)#tunnel-group testgroup type ipsec-ra

hostname(config)#tunnel-group testgroup general-attributes

hostname(config-general)#address-pool testpool

hostname(config)#tunnel-group testgroup ipsec-attributes

hostname(config-ipsec)#pre-shared-key 44kkaol59636jnfx

hostname(config)#crypto dynamic-map dyn1 1 set transform-set FirstSet

jeff

BOINK

bump

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: