There's a mobile version of our website.
I would like to create the following setup;
my internal LAN's are:
I need to connect to this VPN network;
With my own assigned IP Range:
So i need to hide my internal net;
192.168.1.0 / 24
192.168.2.0 / 24
if i need to reach:
without disturbing any;
(there is a nat overload defined;)
ip nat inside source list 12 interface Dialer0 overload
access-list 12 defines some deny's for current vpn traffic and a permit for internal LAN to Internet.
I was thinking by doing this in a route-map?
ip nat inside source route-map VPN interface Dialer0 overload
ip nat inside source static network 192.168.1.0 0.0.0.255 172.26.226.144 0.0.07 route-map VPN extendable
ip nat inside source static network 192.168.2.0 0.0.0.255 172.26.226.144 0.0.07 route-map VPN extendable
access-list 144 deny ip 172.26.226.144 0.0.0.7 172.26.222.0 0.0.0.31
access-list 144 deny ip 172.26.222.0 0.0.0.31 172.26.226.144 0.0.0.7
access-list 144 permit ip 192.168.1.0 0.0.0.255 any
access-list 144 permit ip 192.168.2.0 0.0.0.255 any
route-map VPN permit 10
match ip address 144
Does anybody have some experience doing so?
Thanks in advance for any answer.
For creating VPN between two sites you need public IP's on both sides. !72.26.x.x is a private network IP and cannot be used for VPN if it is over Internet. The internal network 192.168.x.x can be made hidden using a firewall or access lists.
Login to share your discussion activity with your friends on Facebook. You can control what you share and turn off sharing anytime.
Your Facebook friends can now see that you have started this discussion
Your Facebook friends can now see that you have commented on this discussion
Your Facebook friends can now see that you have read this discussion