There's a mobile version of our website.
I have 1601, i cannot access the router through console port , session dos not
any solution for this
Did u check the cable, and the connectors used to access the console ??
Also please check the Hyperterminal (or the software u r using) settings...?? It should 9600 8 1 No flow control..
Hope that helps..
Assuming the router is not active/running,
if you have used/done the following:
1. Correct COM port and Hyperterm settings:
- 9600 baud
- 8 databits
- no parity
- 1 stop bit
- no flow control
2. Correct and working console cable
(A console cable that was previously used in other routers or switch)
and if nothing is displayed in your teminal window after powering ON the
router, then it could be a defective console port or probably a defective router.
Login to share your discussion activity with your friends on Facebook. You can control what you share and turn off sharing anytime.
Your Facebook friends can now see that you have started this discussion
Your Facebook friends can now see that you have commented on this discussion
Your Facebook friends can now see that you have read this discussion