There's a mobile version of our website.
I was given a 510 PIX Ver 6.3(1)to reconfigure but have no information on the existing configuration and need to wipe it clean and start over how can I do this to get back to the factory default settings. I have tried the "monitor>" but I don't know the IP address of the PIX interface.and am not sure how to do the setup for recovering the password.
Thanks for any help with this! :)
Try following the steps from the link below:
Hope this helps.
I think you are misunderstanding the procedure. When you go to monitor mode, you SET the IP address of the inside interface to whatever you want, set the IP address of the tftp server, set the name of the password recovery file on the tftp server. You then initiate a tftp transfer of the file and bingo.... you get a prompt asking if you want to erase the passwords. Works a treat.
I am pretty new at this and I am not sure do I use a direct straight through cable or crossover? I have tried both. But every time I ping I get no response to the address on the computer (tftp server). I must not be doing something right!
Thanks for the help and being more specific.
I did two of these on Monday.
Here's what I did step by step.
1. Set up a tftp server (solarwinds, tftpd, etc) on a local pc. (write down your server IP)
2. Download the image you want from Cisco's website. I used this:
Put it in your default tftp directory.
3. Connect to your Pix via console cable.
4. Power it up and hit escape to enter monitor mode.
5. Connect your Pix to a hub or switch via straight-thru cable. Use port 1 (inside interface)
Optional, connect it directly to PC using crossover cable.
6. On your Pix, do this.
interface 1 <enter>
server <ip of your tftp server> <enter>
file np63.bin <enter> (assuming you used the same file I did)
You should see your tftp server downloading the file - this should happen pretty quickly as it's a very small file.
You'll then see the message:
Do you wish to erase the passwords? [yn] y Passwords have been erased.
Then you should be at the enable prompt.
Do a write erase / reload.
You'll then have a factory fresh Pix 501.
Once you recover your password and login to PIX, issue 'write erase' in enable mode to erase your config. 'reload' the pix and you're back to default setting.
Login to share your discussion activity with your friends on Facebook. You can control what you share and turn off sharing anytime.
Your Facebook friends can now see that you have started this discussion
Your Facebook friends can now see that you have commented on this discussion
Your Facebook friends can now see that you have read this discussion