Welcome to the Community!
The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally.
New Here? Click here to learn more and get started.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1919035members
1223007discussions

Community Activity

Dot1x Configuration in WS-C2960X-24TS-LL

I have Configured the 802.1x Configuration in WS-C2960X-24TS-LL Switch Globally. when i test the aaa test it was successful. but when i tried to configure in the Interface the authentication was not happening. so can you please help to configure the ...

IOS Patch Image failed to be Installed.

Hello Team,I'm facing a challenge to apply a patch on the Cisco ISR4331. See the below error message from the router. SIMBA-RT#install add file bootflash:isr4300_cpld_update_v2.0.SPA.bin activate commitinstall_add_activate_commit: START Wed Mar 27 11...

dissai by Level 1
  • 99 Views
  • 6 replies
  • 0 Helpful votes

Upgrade from SNS-3595-K9 to SNS-3795-K9

Hello, I have two ISE 3595 (3.2 Patch 3) physical appliances, one in each Data Centre. They will be end-of-life in a few months. They are currently used for Wired NAC with Posturing, Wireless NAC (corporate, BYOD and Guest and Hotspot). It is also us...

Resolved! Cisco Prime Collaboration

Dear, before when we have CUCM IP telephony solution. we used to use "Cisco Prime Collaboration" to do "Provision, Assurance & Analytics" for the Cisco Voice Solution. As of today what is Cisco new product which address the End of Sale "Cisco Prime C...

IPSec tunnel encrypt packts but no decrypt

Hi Community, We have a newly established IKEV 1 tunnel from Cisco ASA to AWS. This tunnel is currently at up state but the traffic is not passing through the tunnel. When we enter the show command "show crypto ipsec sa peer X.X.X.X" output have enca...

naveen98 by Level 1
  • 84 Views
  • 4 replies
  • 0 Helpful votes

Resolved! Access Point

Hi all, can the cisco catalyst AP model 9136I, act as Autonomous.

CISCO C1111-4P software upgrade path

I have a C1111-4P router with c1100-universalk9.17.06.01a.SPA.bin image loaded, I want to update to c1100 universalk9.17.13.01a.SPA.So can I update directly to a new image or need to update any intermediate?

fti-it by Level 1
  • 51 Views
  • 1 replies
  • 0 Helpful votes

ANSIBLE BACKUP ON CISCO

Hello Guys,Below playbook is not working, kindly assist look into it and advise. Thanks.Getting below error :-What could I be doing wrong?

fmugambi_0-1711445454310.png fmugambi_1-1711445510456.png
fmugambi by Spotlight
  • 388 Views
  • 14 replies
  • 0 Helpful votes
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: