CAPWAP do not convert to EWC

Hello,We have Catalyst 9100AX series APs. We want to convert one of them to EWC. We tried to factoy reset both however after the reset they are still act like CAPWAP and stuck at  CAPWAP States.P.S. We have WLCs in our network but we isolated the VLA...

Cisco CBS Switch Latest Firmware Availability

Dear Cisco Community,This is regarding availability of latest firmware for below-listed Cisco CBS Segment Switches. Basically, I'm performing Manual Network Audit where I need to provide a list of latest firmware(s) with date & time stamp of release ...

NAT for ping ICMP from outside to inside via ASAv

Hi, I am 4-year student to university of since from Vietnam. I have a problem about ping ICMP through ASA. I can ping from R2 from outside to 4.0.0.1 of DMZ or 8.0.0.1 of inside. I can ping from DMZ via inside. Can also ping from DMZ and inside to go...

Hotline phone service to be available 24/365

Dear Friends,I would like to know the best design and product (Cisco compatibility) for a hotline phone system. The hotline service should be available 24/7 and without downtime. I need around 150 phones to be installed inside the production factory....

test

How to get to know Cisco FTD 2130 throughput

Hello all, I would like to know how to calculate current throughput value at FTD 2130. What sort of information need to calculate it.? Thanks for any response to solve it. 

No ringing back tone from PSTN (SIP trunk) via CUBE

Hello, I have an issue about ringing back tone when I call from outside --> PSTN (SIP trunk) --> CUBE --> UCCX --> redirect call to extension. I hear IVR and can do DTMF. then press extension, no ringing back tone.However when I call from PSTN (SIP t...

MPLS label type unknown

hello, i have enable netflow in egress interface (mpls) in IOSXR 9922 cisco routerwe see there's MPLS label type "Unknown" in several prefixes /32 (IP loopback router)and i have check by perform this command "show mpls forwarding prefixes (iploopback...

While browsing it can't connect ESA with domain name

Hi,When i try to browse ESA with domain name it is not get connected. But when i put ip address then the ESA login page appeared and we can login. what can be the issue? 

ASA <-> Fortigate IPSec VTI Issue

Hello, I am currently testing the IPSec Ikev2 VTI Based (routed-based) interworking of FPR2110 and 3rd party equipment (Fortigate) running ASA OS 9.18(3)56 as shown in the picture above.I understand that in the process of creating a Tunnel interface...

Cisco 3504 DCA problem

Hi Guys,  I have face a very weird issue. Currently my environment are running with 2 x C3504 in HA. There have 18 AP mixed with 1702, 1852, 2802, 9120. Some support for CleanAir some not. Too use all this model, we had choose the version 8.10.130. S...

I don't understand how TACACS Profiles works.

If you look at the tacacs profile as shown in the picture, there are custom characteristics I wonder how this works. In the case of other banders, I understand that tacacs are linked using these attributes If you add a value here, compare it with the...

Cisco anyconnect browser ERR_SSL_Protocol_ERROR

Good day to everyone.I have two Cisco ASA running on FPR2130 assembled into a balancing group, for example:vpn-gw1.example.comvpn-gw2.example.comgeneral address vpn.example.com.Firmware version 9.18.3.56Anyconnect 4.10.07062At the moment, all our emp...