The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally. New Here? Click here to learn more and get started.
Cisco Community is an active and collaborative place to learn more about our products and ask questions of peers and Cisco experts! Check out some of the most popular conversations happening right now!
Hi Community, Iam creating Smart license in IOSXR with http So I used "destination transport-method http" and also put the destination url. When I do show run, i see "destination transport-method email disable" also in the configuration ----- call-ho...
Can any one help me to fix the camera Quad TTC8-10, getting blurry image. - Tried Reboot Camera, Tried Reboot WebEx Device, Tried Reset Camera but unable to get the original view its all blurry image
Hello guys,I installed Cisco room kit EQ, but it's shows Amplifier detection error how to solve this issue,Attached error message and Connection diagram
My org has a single CUCM cluster with around 10k phones registered across 100+ buildings. We've been semi-regularly experiencing an issue that we've had trouble tracking down. Due to the nature of our deployment and the intermittent/difficult to repr...
I'm involved in the following setup illustrated below. I am Site 4. I have a SIP trunk via the CUBE to Site 3. Calls route between Site 4 and Site 1 with no problem. Is it possible to use Site 1 CUCM, to route calls from Site 4 to Sites 3 or 2? Is it...
hello. I understand that Connected routing has an AD value of 0. The IP bands on the 1st and 2nd floors are different. 1st floor: 1.1.1.0/242nd floor: 2.2.2.0/24 There are two firewalls on top of the backbone. The band will be 3.3.3.0/24. If you conf...
Hi,I have tried to retrieve serial number info for 3 units of the Cisco WAP4410N Access Point devices via Web GUI and CLI, but it seems can't find the serial number info for this model. Kindly advise further, thanks.Regards,Wilson Leong
hello all,I recently acquired an old precision 60 camera that was in a container with other broken items. I'm not sure what if anything if wrong with it, but I am trying to see if it works. I do not have the sx80 codec or any other hub for connecti...
Hello, we recently received 2 Cisco CP-8811 phones, and I can't figure out how to get started with them. Currently, we use Polycom phones, which get their provisioning info from an FTP server that contains config files and the "Application". Calls ar...
HeyAt work we have a Cisco Codec Plus and a Quad camera.We mostly use MS Teams, and then I saw this video online:https://www.youtube.com/watch?v=x5DQLGZ1oBs&t=686sAn admin can enable the function, connect a HDMI to a INOGINI device and audio from the...
My expressway version is X12.6.1,Mutual TLS mode is on, both the CA certificate and the server certificate have been imported, then configured an dns zone with TLS verify mode is on ,also have TLS verify subject name, When I initiated the call, I fou...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: