Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
Welcome to the Community!
The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally.
New Here? Click here to learn more and get started.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
1926328members
1238058discussions

Trending Topics

Cisco Community is an active and collaborative place to learn more about our products and ask questions of peers and Cisco experts! Check out some of the most popular conversations happening right now!

Community Activity

Start a conversation

IPSec VPN Tunnel Lan-to-Lan decrypt count zero

Hi, I have one issue with IPSec tunnel Lan-to-Lan between ASA 5525x (v9.8) and ASA FPR 2110 (v9.16). My Tunnel is up but ping between each client was not successful. Both peer status sh cry isakmp sa in "MM_ACTIVE".I ran packet-tracer icmp between pe...

El Rondo by • Level 1
  • 195 Views
  • 10 replies
  • 0 Helpful votes

Snort3 not recognising SMTP/S but Snort2 did/does !?

I'm in the process of updating all our FTD's from Snort2 to Snort3 & almost everything appears to work, except SMTP/S email.Under Snort2 it shows in event logs as SMTP/S Client traffic type correctly, but when Snort3 is enabled, it does not recognise...

ida71 by • Level 1
  • 103 Views
  • 3 replies
  • 0 Helpful votes

CUCM Dual Forking Capabilities

We are trying to accommodate an employee with hearing impairment so that they can use a TTY Display AND there is a compliance need for call recording.  Has anyone been able to overcome this obstacle?  We are running up against the inability for Call ...

Err-disable on port 3850 -12xs switch

I'm a newbie but have a question: I upgraded my Palo (firewall ) and the port that the firewall is plugged into err-disables out. After doing a SHUT, NO SHUT the port came back to life. Any thoughts on why this happens? It seems to happen anytime I u...

ISE Cert Question

HiDo I need to generate a CSR for a cert on ISE its a *cert or can I just add the cert to the ISE Nodes for Portal use.?? Thanks

Cisco 9300X Static routes don't work to SVI Tunnels

NOTE: I have done the same test setup with 4000 series routers, and routing works fine.I have successfully setup 3 SVI (Static Virtual Interface) tunnels with IPSEC between 2 9300X switches.- I can ping the tunnel IPs- I can ping each VLAN interface ...

Cannot add FTD to FMC after deleting it from FMC

Hi,FTD was added and to FMC and while configuring HA in FMC, deleted FTD from FMC.While trying to add again to same FMC, both primary and secondary FTD not getting registered in FMC.Could you please help on getting the FTD registered with FMC.

riyas_tvm by • Level 1
  • 51 Views
  • 3 replies
  • 0 Helpful votes

L2VPN Over GRE

Hi I'm trying to extended a L2 segment using MPLS L2vpn over GRE. I am able to establish the tunnel and get ospf and mpls adjacency also the xconnect between the peer is up but my 2 test pc cant reach each other. This is my PE3 config.interface Gigab...

PKCS12 (PFX) without a supplied password error

We have clients receiving a "PKCS12 (PFX) without a supplied password" error while connecting to RAVPN using Cisco Secure Client (5.1.2.42). The headend device is FTD 3130.The full error is "There was an erro during initialization: PKCS12 (PFX) witho...

SNTC Aging Timer

We are noticing that devices that are no longer on the network eventually drop out of the collector.  No issues there but we are wondering what the time period is and if it can be changed for how long a device stays in the collector once it is no lon...

Load more
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: