The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally. New Here? Click here to learn more and get started.
Cisco Community is an active and collaborative place to learn more about our products and ask questions of peers and Cisco experts! Check out some of the most popular conversations happening right now!
Hello, I have two ISE 3595 (3.2 Patch 3) physical appliances, one in each Data Centre. They will be end-of-life in a few months. They are currently used for Wired NAC with Posturing, Wireless NAC (corporate, BYOD and Guest and Hotspot). It is also us...
Hello community!This is my first time typing here so I am hoping I do not mess this up, lol! I am testing some automation code to upgrade SDWAN controllers from code 20.10.1 to 20.12.2 on Sandbox, and the code works to stage the image and then activa...
Greeting everyone! There is a little problem with configuring tacacs server on ws-2950-24 model switch. The rest switches we have are 2960 series, also 3xxx series and others, more modern versions. We always configured tacacs server this way:tacacs-s...
we have CBS350-24P-4G fiber port not coming upNAME: "GigabitEthernet25" DESCR: "SFP-100Base-LX"PID: SFP-100-LX VID: Information Unavailable SN: 9802222809DataSwitch1F#sh fiber-ports optical-transceiver interface gi25Port Temp Voltage Current Output I...
Hello,We had a perfectly functional ISE 2.7 posture deployment, but we had to upgrade to ISE 3.2.We set up another deployment & imported our 2.7 conf into the 3.2. Since then, our computers never go through the full posture process.We're using Anycon...
Hi All , I am in the testing phase of migrating to a 9300. So far I have done the below.3850 running 16.3.6 and 9300 updated 17.09.04aI have copied the start-up config to the 9300 - all looks ok apart from the usual ip routes , some interfaces not ...
I am using a cable from Console to serial, and that cable connected from serial to usb and i am using PuTTY. I have tested this setup with a Catalyst 2960 switch and i got output, but when i am using the same configuration for the 2504 Wireless contr...
good afternoon, I believe I have everything downloaded like I should have and I'm pretty sure that I've established a secure VPN with cisco. For some reason I cannot see this import button like on the instructions under lab topology. it says I have ...
Hi guys, since a few days i have the issue that my terraform apply don't work anymore. A few weeks ago it worked fine and i don't changed any versions. Anytime when i try to deploy Access Policies is see the following change: # module.aci.module....
Hi Community, We have a newly established IKEV 1 tunnel from Cisco ASA to AWS. This tunnel is currently at up state but the traffic is not passing through the tunnel. When we enter the show command "show crypto ipsec sa peer X.X.X.X" output have enca...
Has anyone come across a guide to configuring CER to handle calls to 933. When doing post-deployment testing, I would love to be able to dial 933 at sites rather than bothering the PSAP. I've seen suggestions about configuring sites with 933 instea...
Ask Me Anything Event Welcome to the Cisco Community Ask Me Anything conversation. Submit your questions from Friday, March 15, 2024 through Friday, March 29, 2024. Our colleagues Pandian Ponnuswamy, Gautami Sinai Neureker and Sankkar R will be w...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: