Welcome to the Community!
The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally.
New Here? Click here to learn more and get started.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1927429members
1240141discussions

Community Activity

Get report status endpoint from ISE

Dear Community,There have 2 kind different of AnyConnect agent version on ISE.Also have 2 kind of Complain Module as well.Please share how to get the report from ISE with below points.how to get the report status of endpoint with new version and old ...

Da ICS16 by Level 1
  • 0 Views
  • 0 replies
  • 0 Helpful votes

Can I change the regulatory domain for our new CW9164I-ROW AP?

We have a 9800-CL Wireless Controller running 17.12.2.  We just got a new CW9164I-ROW AP and its registered by the operational interfaces are down due to a regulatory domain error.  Is there a way to change the regulatory domain for the access point?...

9200 switch loosing its configuration

Hi guys, One of my friend is facing a issue and it seems quite weird.2 of his 9200 switches lost their configuration even though configuration was saved and even if for some reason switch restarted but they should not  loose its configuration. what c...

Cisco Packet Tracer 2960-24TT indicates Orange (amber)

Hello everyone. I work in Cisco Packet Tracer and have a simple network with 5 subnetworks connected through 2960-24TT Switch. The problem is when i connect 5 subnetworks to 1 network some (3) routes light orange (amber). And i can`t fix it. Where sh...

photo_2024-04-19_03-40-10.jpg photo_2024-04-19_03-40-13.jpg

Puzzling results when pasting in ACL config to switch

Hello, I was creating 2 decently large ACL's to match some traffic today and I noticed something peculiar that has me puzzled. My first ACL has approx 90 ace's and pastes them fine. When I go back and look at the ACL, it looks like there are only lik...

QOS on Catalyst 9300,not showing captured packets.

Have applied the below policy map in OUT direction but I couldn't see the packets count increased but instead the total bytes output get increases. At the same time policy towards ingress which captures the match protocols increases.Input policy-For ...

VRRP issue

Facing issue with VRRP, when upstream router5 initiate traffic for downstream router6 then return traffic is not following VRRP VIP as Gateway. In my case switch2 is master and switch3 is standby.If Router6 initiate the traffic then VRRP working fine...

IOS-XE: MP-BGP における ipv4 over ipv6 の設定について

MP-BGP( Multi Protocol BGP )では IPv4 以外に IPv6 もネイバーの確立に使用できるように拡張しており、ipv4 over ipv6 設定もできます。     R1#show run interface Loopback0 ip address 1.1.1.1 255.255.255.255 ipv6 address 2000::1/128!interface GigabitEthernet0/0/0 ip address 10.1.1.1 255.25...

a4d2edbf-461f-40af-a197-692dd44e396d.PNG
hongwli3 by Cisco Employee
  • 18 Views
  • 0 replies
  • 0 Helpful votes

QOS for a Destination-ip in Cisco IOSXE

Hi All,We have a URL which resolves to particular public ip and performance of that website is slow than expected from our office . We have a P2P link from office to DataCentre and from DataCentre it exits to internet. We observed the performance was...

CESアップグレードについて

はじめに一斉アップグレードの抑止リクエストアップグレード日程調整のリクエスト   はじめに 新しいバージョンのAsyncOSがリリースされてから一定期間が経過するとCESが自動的にアップグレードされます。このアップグレードは一斉アップグレード(mass upgrade)といいます。アップグレードの予定時間はCESステータスページ( https://status.ces.cisco.com/ )にて確認できます。記載された時間よりあとにアップグレードをご希望の場合は、事前にTACにご連絡ください。...

kaixzhou by Cisco Employee
  • 41 Views
  • 0 replies
  • 0 Helpful votes
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: