The Community is a hub for connecting with your peers and Cisco specialists to ask for help, share your expertise, build your network, and grow professionally. New Here? Click here to learn more and get started.
Cisco Community is an active and collaborative place to learn more about our products and ask questions of peers and Cisco experts! Check out some of the most popular conversations happening right now!
Hi, I can barely make this post so I'm writing it very basically.I'm getting this error (in the title) when trying to start a webex meeting.May anyone please help?
Dear TeamI have downloaded the vfmc for esxi 7.4.X and 7.3X but i cannot deploy in VMware after deployment its retturn "operating system not found"any ideaRegards
Hi all,We had WSA appliance and we are migrating appliance to virtual environment.We have configured new WSA and tested and its working fine and now we are planning to move it to LIve so we are planning to change the data ip.of new virtual WSA to the...
Can anybody tell me what exactly is the difference between the radio MAC address vs the ethernet and Wi-Fi mac addresses? What is the purpose of the radio MAC address? Apparently, wireless access points don't just have an ethernet and Wi-Fi MAC, but ...
This is a 2-server cluster of CUCM 12.5It is a small deployment of around 100 phones that don't handle a large volume of calls.I'm pulling logs for the CallManager service.Typically I would expect to be able to go back at least weeks but I can't pull...
hi guys . i have a network with below topology. In the core layer, I want to have redundancy, which means that if the main core switch of my network has a problem, the backup switch will automatically enter the circuit. What method is there?
Cisco Unified CM AdministrationSystem version: 12.5.1.13900-152Can anyone explain “last active” and “last registered” on call manager, Find and List Phones page?It’s my understanding that “last active” displays the timestamp when a device was last ac...
Hello,I would like to update our server usc m4 from GUI and not from ISO boot media. I found that i can do that by following:However, I cannot find the .bin for Bios or BMC in (ucs-c220m4-huu-4.1.2m.iso). How do i download them ?
Hello all, I have inherited an infrastructure with several catalyst 9200 switches. A few of them are unreachable when using ssh from a terminal, such as a linux server or Powershell. The error message is this: Unable to negotiate with <IP ADDRESS> po...
Time of Day Routing - Monday through Friday set hours, and Saturday different hours than Monday through Friday.I want to use "Time of Day Routing" for a Monday through Friday schedule and a Saturday schedule with different hoursMonday through Friday ...
How long will a message be available in the message tracking on the SMA?I cannot seem to find any information pertaining to this on Cisco's website. Thanks!
Good day;Need help with how I can configure NAT overload with an existing vrf on a CAT9K_IOSXE V16.12. This is what I am struggling with, I currently have a vrf called AWSDX-S3. Now what I am trying to do is I have added a L2 SW and ran trunk ports...
Hello,I have an IKEv2 Site-to-Site IPSec tunnel (VTI with static routing) between ASA firewall and 2 stateless HA routers configured with HSRP (IPSec end point is HSRP VIP hosted on the HSRP active router).Despite the fact it is not stateful (not sup...
I am repurposing a B200 M5.The server has 2nd Generation Intel Xeon Scalable ProcessorsI have 2 x 64GB and 2 x 32GB DIMMS.Referring to the Cisco UCS C220/C240/B200 M5 Memory Guide, I'm not sure what is the preferred method of populating memory.Should...
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: